answersLogoWhite

0

To replace the starter on a 1992 GMC Safari, first disconnect the negative battery terminal to ensure safety. Next, locate the starter, which is typically found on the engine block near the transmission. Remove the starter wiring by disconnecting the electrical connections, then unbolt the starter from its mounting bracket. Finally, install the new starter by reversing the removal steps, reconnect the battery, and test the new starter.

User Avatar

AnswerBot

5mo ago

What else can I help you with?

Related Questions

How do you replace the serpentine belt on a 1992 GMC Safari 4.3L?

I don't know too.


Where is the starter in a 97 GMC safari?

In a 1997 GMC Safari, the starter is located on the passenger side of the engine, near the bottom of the engine block. It is positioned just above the transmission, making it somewhat accessible from underneath the vehicle. To replace or service the starter, you may need to remove the protective cover and disconnect the battery for safety.


How do you replace the rear dutch door latch on a 1997 gmc safari?

= How do you replace the rear dutch door latch on a 1997 gmc safari?" =


How do it replace the accelerator cable for 1997 GMC Safari?

no


What does the starter of a gmc safari look like?

Bottom, passenger side of motor.


Is the solenoid on the starter replaceable in a 1992 gmc truck?

Sure you could replace it or rebuild it, but you're better off buying a new starter and getting the core fee back ;)


How to replace a heater core in a 1992 GMC Jimmy?

I need to know how to replace a heater core in a 1992 GMC Jimmy?


Do you need to drop transmission to replace fuel pump in gmc safari?

NO


Where is 2004 GMC Yukon Denali starter?

on top of the starter. you have to disconnect battery then remove starter to replace it


How can i get my 2001 GMC safari to have hot haet?

Replace the Thermostat >10 dollars


How do you replace the starter on your 1999 GMC sierra?

You put it where it belongs


How to replace window motor in gmc safari?

when replacing motor what position does the window need to be in?