answersLogoWhite

0

To replace the AC compressor on a 1996 Oldsmobile Achieva, first, ensure the AC system is discharged properly to avoid refrigerant leaks. Next, disconnect the battery, remove the drive belt, and unbolt the compressor from its mount. Disconnect the electrical connectors and refrigerant lines, then install the new compressor by reversing the removal process. Finally, recharge the AC system with the appropriate refrigerant and check for proper operation.

User Avatar

AnswerBot

5mo ago

What else can I help you with?

Related Questions

Where is the oil sending unit on a 96 Oldsmobile Achieva?

On my 95 it is above the starter. it might be the same.


Idle RPMs for 96 Oldsmobile achieva?

Most cars are anywhere between 750-800 rpms


How do you change headlight on Oldsmobile Achieva 96?

To change the headlight on a 1996 Oldsmobile Achieva, first, open the hood and locate the headlight assembly. Remove the retaining clips or screws securing the assembly, then carefully pull the assembly out. Disconnect the wiring harness from the back of the headlight bulb, replace the bulb with a new one, and reconnect the wiring. Finally, reinsert the headlight assembly and secure it back in place.


What does a flashing high beam light on a 1995 Oldsmobile Achieva mean?

i have a 96 olds achieva and my high beam light was flashing, i checked the headlights and one of my low beam headlights was out. once replaced the flashing stopped.


Labor cost to replace the ac compressor in a 96 cadillac?

Labor. Cost to replace ac com pressor in a 96. Cadillac debille


My ac won't work on 96 blazer?

It is possible the air compressor is bad. You will need to replace the air compressor, so the air will work again.


How do you replace ac compressor on 96 suburban?

If you can't figure that out by looking at it, you need to pay someone else..


How do you replace a serpentine belt on an 97 Olds Achieva?

replacing achieva serpentine on a 96i have a 96 and you have to completely remove the motor mount and all of the bolts holding it on the engine to replace the belt,also carefully jack up the engine since it will fall on the ground if you take off the mount


How do you replace the transmission mount on a 96 Oldsmobile achieva 4-cylinder do you have to remove the whole engine?

no you do not have to remove driver side wheel and there is 3 bolt that hold it to the transmission and one bolt threw the center. the 3 bolt should be 15mm head and the one that in center the nut is 15mm and the bolt 17mm


How do you bleed cooling system 96 olds achieva?

To bleed the cooling system on a 1996 Oldsmobile Achieva, first ensure the engine is cool. Remove the radiator cap and start the engine, allowing it to reach operating temperature. As the thermostat opens, air bubbles will escape; keep an eye on the coolant level and add more if necessary. Once the bubbles cease and the coolant is at the proper level, replace the radiator cap securely.


96 Oldsmoble Achieva should the starter have 4 wires plugged in or 2 wires?

96 Oldsmobile achieva and wont start and the security light is on a gm dealer took the security system out and the security light is still on and car wont start now should the starter have 2 wires plugged into it or 4 plugged into it for the car to start plz help me i need my car


Horn don't work on 96 Oldsmobile ciera?

If the horn does not work on a 1996 Oldsmobile Ciera, you can replace the horn. Almost any type of horn should be compatible.