== ==
To change the ignition switch on a 1975 Dodge D100, first disconnect the negative battery terminal to ensure safety. Remove the steering column covers to access the ignition switch, then locate the ignition switch mounting screws and remove them. Disconnect the wiring harness from the old switch, replace it with the new ignition switch, and secure it with the screws. Finally, reassemble the steering column covers and reconnect the battery.
== == It's on the floor sometimes hidden by the carpet.
To remove the ignition switch in a 1975 Ford Granada, first disconnect the battery to ensure safety. Remove the steering column covers by unscrewing the screws that hold them in place. Next, locate the ignition switch, which is typically mounted on the steering column, and disconnect its wiring harness. Finally, unfasten the screws or bolts securing the ignition switch and carefully pull it out.
If the engine is in good condition dont replace it,supercharge it.
It is easy . Go to auto parts store buy the ignition switch since directions are in the box. You will need one piece that you can make to hold the springs in place while removing it and replace it . Allow 4 hours for a beginner.
http://www.google.com/ Google it. :)
The fuse box on a 1975 Chevrolet Corvette is almost directly above the dimmer switch. It may take a flashlight to find the exact location. If is about six inches square.
that's the rear window defroster. up is hi, down is low, middle off.
You can order it via the Eckler's Corvette website.
== ==
On a 1975 Johnson outboard motor, the kill switch is typically located on the control box or the engine itself. It often takes the form of a lanyard that, when pulled, disconnects the ignition circuit to stop the engine. You can usually find the switch on the throttle control or near the ignition key. Always consult the owner's manual for the specific location and operation instructions.
Haynes repair manual.Chev corvette 68-82($20)