0
You jack up the one corner of the vehicle and place it on a jack stand. then you remove the tire. Then remove the upper balljoint castle nut and split the ball joint. Then all that's left is to remove the two bolts securing the control arm to the frame and you should be able to pull the control arm out.
What else can I help you with?
How do you replace the ball joints on a 02 Dodge Ram 1500 4x4 can they be pressed out of the steering knuckle or control arm or do you have to replace the entire steering knuckle or upper control arm?
They are pressed in and out with a set of special tools.
Why does my 03 Dodge Dakota lose control when I hit a set of small bumps at low speed?
Replace the front upper and lower ball joints.
Where is the thermostat on a 1994 Dodge Ram pickup?
It is under the housing that the upper radiator hose hooks to on the engine.
How do you replace rear shocks on 1989 dodge d100 pickup 2 wheel drive?
To replace the rear shocks on a 1989 Dodge D100 pickup 2WD, first, safely lift the vehicle and secure it on jack stands. Remove the lower shock mounting bolt using a socket wrench, then detach the upper mounting bolt in the same manner. Install the new shock by positioning it in place, securing both the upper and lower bolts tightly. Finally, lower the vehicle and check for proper installation and clearance.
Where is the speed sensor wire on a 2003 GMC pickup?
It's attached to the wheel hub and plugs in on the chasis above the upper control arm. I think you have to replace the entire wheel hub to fix it.
How do you replace the upper ball joint on a 1994 Isuzu pickup?
To replace the upper ball joint on a 1994 Isuzu pickup, start by safely lifting the vehicle and removing the front wheel. Disconnect the brake line and remove any components obstructing access to the upper control arm, such as the shock absorber or sway bar link. Use a ball joint separator tool to detach the ball joint from the control arm, then remove the retaining bolts and replace the old ball joint with a new one. Reassemble the components in reverse order, ensuring everything is securely tightened.
How do you replace the upper ball joints on a 1996 Plymouth Breeze do you need to replace the whole control arm or are they pressed in?
You have to replace the whole control arm on front upper ball joints in that particular vehicle.
How do you replace upper ball joint on 2002 sierra?
Part Of Upper Control Arm
How do you Replace upper threaded ball joint on 2002 dodge van?
To replace the upper threaded ball joint on a 2002 Dodge van, first lift the vehicle and remove the front wheel for access. Disconnect the upper control arm from the steering knuckle and any associated components, then unthread the old ball joint from the control arm using a ball joint removal tool. Install the new ball joint by threading it into the control arm, then reassemble by reconnecting the control arm to the steering knuckle and reinstalling the wheel. Finally, lower the vehicle and check for proper alignment.
What exactly do the four control knobs on a typical 2 pickup electric guitar control and which control is which?
Starting with the lower aft knob (the one closest to the input jack) and moving clockwise, the controls are as follows: Tone Control for the Bridge Pickup, Tone Control for the Neck Pickup, Volume Control for the Neck Pickup, Volume Control for the Bridge Pickup. The switch (usually located on the upper horn if you're playing a Les Paul) is used to switch between the pickups. Hope this was helpful!
What is the torque spec for tightening a upper control arm on a 95 dodge Dakota 4 wheel drive?
155 ft. lbs. for the upper control arm-to-frame bolts.
How do you replace the upper and lower ball joints on a 2002 Chevy S10 pickup truck?
If its 2 wheel drive, you will need a press. Those ball joints are pressed into the upper and lower control arms. If it is 4 Wheel drive you need to remove the rivets with either an air chisel or to drill them out.
