0
Pop open the back gate, and you'll see two screws that hold the tail light in place. Take the screws out, and the tail light should swing out slightly and then pull straight back and out of the truck. There's two rubber "pegs" that hold the light in to the truck on that's opposite of the screws. You just need to give it a little pull and the light will come out. From there, you'll see 3 light harnesses connected to the light assembly. Twist counter-clockwise and the harness will disconnect from the light assembly.
What else can I help you with?
How Replace brake light suburban?
expose back of bulb, turn to the left, replace bulb, return to socket, turn to the right
Why do your left rear tail light and blinker not work on your 1997 suburban?
Bulb is blown. Replace bulb.
How do you replace a 1999 suburban tail light bulb?
The tail light bulb on a 1999 Chevy Suburban is replaced by removing the retaining screws, pulling the bulb assembly away from the vehicle, and unscrewing the bulb. A new bulb can then be installed and the assembly screwed back in place.
How do you replace light bulb in 2008 Toyota Sienna?
To replace a light bulb, you have to: if its in the front, you have to open up the hood and look for the screws that are connected to the lights. For the back, you have to: open the trunk, and unscrew the light bulb, open it up and replace it.
How do you replace service engine light bulb on 98 gmc suburban?
To replace the service engine light bulb on a 1998 GMC Suburban, first disconnect the negative battery cable to ensure safety. Remove the instrument panel by unscrewing the necessary screws and gently pulling it out. Locate the bulb socket for the service engine light, twist it counterclockwise to remove, and replace the old bulb with a new one. Finally, reassemble the panel, reconnect the battery, and check that the light functions properly.
How do you replace bulb on high mount stop light on 2004 Chevy suburban?
if it is an LED unit you cant you have to change the assembly as a unit
How do you replace daytime running light on 2010 suburban?
To replace the daytime running light on a 2010 Chevrolet Suburban, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then carefully pull it out. Disconnect the electrical connector from the old bulb, replace it with a new bulb, and reconnect the connector. Finally, reassemble the headlight assembly and secure it back in place.
How do you replace a side marker bulb on Chevy Trailblazer?
how do you replace side marker light on 2008 chevy trailblazer
How do you replace 2008 Hyundai accent license plate light bulb?
To replace the license plate light bulb on a 2008 Hyundai Accent, first, locate the license plate light assembly at the rear of the vehicle. Use a flathead screwdriver to gently pry off the light cover. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb by twisting it clockwise until secure. Finally, reattach the cover and ensure the light functions properly.
How do you replace the tail light bulb on a 2008 Audi A-6?
To replace the tail light bulb on a 2008 Audi A6, start by opening the trunk and removing the access panel or cover located behind the tail light assembly. Once exposed, twist and remove the bulb holder from the assembly, then pull out the old bulb and replace it with a new one, ensuring it clicks into place. Reinsert the bulb holder back into the assembly, replace the access panel, and test the new bulb to confirm it’s functioning.
Replace stop light bulb on 2006 Colorado?
How do it replace the stop light bulb
How do you replace a backup light on a 2009 Buick enclave?
how do you change a back up light bulb on a 2008 buick enclave
