0
First, find the battery, there are two thick wires, one marked " - " and the other marked "+", these marks are usually on the battery too, first remove the " - " wire using a 10 or 12 mm open end wrench, then remove the " + " wire, also remove the fastener which fixes the battery to the car (normally 2 10 mm nuts), then lift the battery out of the car, if you already have the new battery, reverse the process to install. Be sure to have your radio, anti theft, and alarm codes written down before doing this, some electronic equipment resets itself to factory settings if you remove the battery.
Be careful with pulled muscles or entrapment of fingers,the battery is quite heavy and if mishandled it will hurt you.
Do not drop the battery, if it falls on your foot it will break a bone.
Do not drop the battery, there is sulphuric acid inside, if it falls it could brake and spill a very nasty substance, if this happens (it's quite tough, it shouldn't break), do not touch or breathe the liquid or vapors, neutralize the acid with environmentally safe alkali soap and rinse with plenty of water.
Do not smoke close to the battery, these emit hydrogen and are highly flammable.
Do not connect one post to the other (+ to -), this could cause the battery to explode and it will blind you and burn you severely.
Be extremely careful when reinstalling, + cable goes on + post and - cable goes on - post, if you reverse the connection you will burn all your car's electronics, this will be very expensive to fix.
Be sure to get the correct battery for your car, There are batteries with the posts located in different positions and orders, you will not be able to connect them if the battery is not the correct one, those thick wires are short and do not bend easily.
What else can I help you with?
Where is the battery on a 2013 Chrysler 200?
The battery on a 2013 Chrysler 200 is inside the left front fender.
How do you replace battery on a 2012 Chrysler 200?
To replace the battery on a 2012 Chrysler 200, first, ensure the vehicle is turned off and parked on a flat surface. Open the hood and disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove the battery hold-down bracket and carefully lift out the old battery. Place the new battery in the same position, reconnect the positive terminal first, then the negative terminal, and secure the hold-down bracket.
Where is the car battery located on Chrysler 200 2013?
The battery is in the driver side fender.
Where is the battery in a Chrysler 200?
The battery is inside the driver side fender, in front of the tire.
Where is the battery on a 2011 Chrysler 200?
The battery is inside the driver side fender in front of the tire.
Replace battery in Chrysler 300 key fob?
Just call Parts, the battery costs $6.00 you can replace it yourself.
Where is the battery in a 2013 Chrysler 200?
The battery is in front of the driver side front tire inside the fender.
Where is the battery in a Chrysler 200 limited convertable?
The battery is in front of the left front tire, inside the fender.
Why wont your 2004 Chrysler sebring start up after you replace the battery?
Because you didn't charge the battery.
Where is the battery in a 2011 Chrysler 200?
The battery is inside the driver side fender.
Died battery on a Chrysler 300?
Recharge, replace, test charging system.
Dead battery in 1997 Chrysler Sebring convertible?
Charge it, test it, replace it.
