answersLogoWhite

0

AnswerThe brake rotor free-floats on the hub assembly. But, you have to remove the brake caliper mounting bracket (2 15mm bolts) from the hub to actually clear the way for it to be removed.

See "Related Questions" below for more

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you replace third brake light bulb on 2002 Mercury Sable?

Its a whole led unit replace whole deal not bulb


What kind of brake fluid do you use for a Ford Taurus - Mercury Sable?

Per the Owners Manual, DOT 3 type brake fluid.See "Related Questions" below for moreDOT 3 brake fluid


What brake fluid for 1997 Mercury Sable?

For a 1997 Mercury Sable : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )


What is the you p brake light mean in the Mercury Sable?

'P'arking or emergency brake


How do you replace brake line on a 1999 Mercury Sable?

To replace the brake line on a 1999 Mercury Sable, first, safely lift the vehicle and secure it on jack stands. Locate the damaged brake line, then use a line wrench to disconnect it from the brake components and remove any mounting clips. Cut and replace the line with a new pre-bent brake line, ensuring proper routing and securing it with clips. Finally, bleed the brake system to remove any air before testing the brakes.


What brake fluid should be used on a mercury sable?

DOT 3 brake fluid


How do you diagnose brake problem on a 1995 mercury sable?

What kind of brake problem(noise,pulling)?


What is the bulb type for a Ford Taurus - Sable tail light bulb?

There are a couple of bulbs in the taillight: turn, brake & backup.See "Related Questions" below for a Taurus/Sable lightbulb-round-up...


Brake lights not working - how to check brake light switch on a Taurus - Sable?

To check the brake light switch on a Ford Taurus or Mercury Sable, first ensure the vehicle is turned off and the keys are removed. Locate the brake light switch, typically found near the brake pedal. Inspect the switch for any visible damage and use a multimeter to test for continuity by pressing the brake pedal—if there's no continuity when the pedal is pressed, the switch may need replacement. Additionally, check the wiring and connections for any signs of wear or disconnection.


What is the size of rear brake lines on a 1998 Mercury Sable?

3/16


What is fuse 17 on 99 Mercury Sable?

On a 1999 Mercury Sable : In the fuse panel by the brake pedal : ( # 17 is a 30 amp fuse for the front wiper / washer )


What does ip mean on the dashboard Mercury Sable 1998?

If you mean the exclamation point and the " P " above the word " BRAKE " in the lower right side of the gauge cluster in a 1998 Mercury Sable that means either the parking brake / emergency brake is on , or the brake fluid level in the brake master cylinder in your engine compartment is LOW