the brake switch is located on the upper part of the brake pedal arm. To remove it will require the use of a wrench as this switch is retained with a nut. It is a simple procedure but will take some time because of its location.
Note: if you are experiencing problems with the brake lights not turning off it is probably not the switch. Instead it is likely a rubber stopper which needs to be replaced. There are blue rubber stoppers used on the pedal arms. If these stoppers have dried up and broken off the brake lights will remain on. This small gap created by the absence of the stopper allows the switch to act as if your foot is on the pedal
How do you replace the hazard switch
1997 escort tranny's are a breed of their own you must replace it with a 1997 transmission.
No, the engine does not have to be removed.
how to replace break pads on 2001 4runner
Most likely either the switch or the motor is defective.
how do i replace a transmission sensor switch on a 2001 l-series saturn
It is quite simple to replace the flasher relay switch on your 2001 Kia. The flasher relay switch simply plugs in and out.
how to replace the brake light switch at the pedal of a 2001 ford zx2
On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.
http://www.automotivehelper.com/topic1054152.htm or Goole "ignition switch replacement 2001 regal"
Remove the dash bezel, remove the switch, reverse process with new switch.
The neutral safety switch is located on the side of the transmission at the linkage connection. Unhook the wiring connector, Disconnect the linkage, then unbolt the switch to replace it.