drain out coolant to a point were hose is clear, remove hose then replace,add coolant to bring up to normal level...will loose a bit of coolant but not much!!
it is on engine block on right side faceing it, just about even with radiator hose. at end of radiator hose in housing.
Remove the 2000 Chevrolet Malibu washer tank supply hose. Remove the windshield washer tank retaining bolts. Reverse the process to install the new windshield washer tank.
I have a 2000 Malibu, I can help you out if you can give me some more info...where on the intake manifold are you referring to?
Begin by removing the bottom radiator hose. Allow the old coolant to drain out. Replace the hose to its original position. Fill the radiator with new coolant.
To replace the thermostat in a 2000 Toyota Avalon, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant, then remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with the new one, and reassemble by tightening the housing and reconnecting the hose. Finally, refill the coolant, start the engine, and check for leaks.
blown brake hose, front passenger side in 1997 chevy malibu?
Just above the top radiator hose the leads into the engine.
To replace the AT coolant hose on a 1999 Jaguar XJ8, first, ensure the engine is cool and disconnect the negative battery terminal. Drain the transmission fluid and coolant, then locate the AT coolant hose, which runs from the transmission to the radiator. Loosen the clamps and carefully remove the old hose, then replace it with the new one and secure it with the clamps. Refill the transmission and coolant systems with the appropriate fluids, and reconnect the battery terminal before starting the engine to check for leaks.
What is a "belt hose" What is a "belt hose"
just follow the upper radiator hose to engine, and you will find it.
To replace the thermostat on a 2000 Oldsmobile Silhouette, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator and remove the upper radiator hose connected to the thermostat housing. Unscrew the thermostat housing, take out the old thermostat, and clean the mating surfaces. Install the new thermostat, reattach the housing and hose, refill the coolant, and reconnect the battery.
To replace the thermostat on a 2000 Isuzu Trooper, first ensure the engine is cool, then drain the coolant from the radiator. Next, remove the upper radiator hose and unbolt the thermostat housing to access the thermostat. Replace the old thermostat with a new one, ensuring the gasket is also replaced, then reassemble the housing, reconnect the hose, and refill the cooling system with coolant. Finally, check for leaks and start the engine to ensure it reaches operating temperature.