The hardest part of the job is GETTING TO the freeze plug. Depending on which one is leaking, sometimes you need to pull quite a bit of stuff just to get to the freeze plug.
You need to be able to examine it and have clear access to the freeze plug and if it's one of the rear plugs (under the flywheel), you're only option is to pull the engine and/or transmission.
Once you can get to it, just drive a screwdriver or other sharp object through the freeze plug and pry it out. Clean the block around the freeze plug then install one of the aftermarket types, preferably one that allows you to tighten a bolt to install it. You'll have trouble getting an original type freeze plug to seal if you don't have the engine block sitting on a workbench.
Any time you have an engine machined, always replace the freeze plugs.
how much does a mechanic charge to replace a freeze plug on a chevy el camino 8.0
where is the freeze plug located on a 1992 Chevy beretta and I need a picture on it also
Replace freeze plug in a 1998 ford windstar ?
How do you replace freeze plug 1999 Ford Taurus?
Replace the freeze plugs.... All of them. Chances are if one has rotted through, the others aren't far behind.
Where is the freeze plug. On a 1996 lumina3.1v6
Should be 1 at the front of engine 1 at the rear of engine on each side Punch a hole in the center of freeze plug and pry out
Should be three on each side and two in the rear under the bellhousing.
the car is smoking on the left side is it the freeze plug?
freeze plug location 9 9 chevey Malibu
take a large screw driver and a hammer tap the old freeze plug in the block,replace it with a rubber freeze plug.tighten the rubber freeze plug with a wrench..the metal freeze plug that you pushed inside the block will not hurt anything..hope this helps!!!!
there is not just 1 freeze or (soft) plug, there is about 8 give or take a few