Remove the rotor. Knock the remaining stub out with a hammer and punch. Go to a parts store and buy a new stud/w nut. Place the new stud into the hub, and draw it down tight with the nut, installed temporarily backwards.
in front of steering wheel in engine compartment ( two small caps on rectangular block )
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
check your struts sounds like they are worn out
The 1989 Oldsmobile was most definitly a front wheel drive vehicle.
To replace the front wheel bearing on a 1989 Ford Festiva, start by safely lifting the vehicle and removing the front wheel. Next, detach the brake caliper and rotor, then remove the axle nut and hub assembly. Once the hub is accessible, use a bearing puller to remove the old bearing, clean the housing, and press in the new bearing. Finally, reassemble the hub, rotor, caliper, and wheel, ensuring all components are securely fastened.
The wheelbase of the 1989 Dodge pickup varies by model, typically around 117.5 inches for the short bed and 131.5 inches for the long bed versions. The wheel track, which is the distance between the centerlines of the left and right wheels, is approximately 60 inches in the front and 62 inches in the rear. These dimensions contribute to the truck's stability and handling characteristics.
I believe it's 104.3"
5 bolt pattern
All Chevrolet Celebrity cars are FWD (front wheel drive).
Do not believe there were any Dodge Spirits made until 1989! Dodge Spirits was made from 1989-1995, that's when they was replaced by the Plymouth Breeze and the Dodge Stratus.
the front bearings on the 1989-thru-1997 ford thunderbird/mercury cougar cannot be changed, the whole front hub comes as one piece and have to be replaced as a single unit.
Neither the front or rear bumper of a 1989 Chevrolet truck will fit on a 1989 Dodge truck. The bolt patterns are different and will not line up.