you will need to take the fuel tank out because it is inside of the tank.just put a new fuel sending unit in and you should be good to go.
The sending unit and the fuel pump are all one module in the gas tank.
The fuse panel in a Pontiac Montana is located in the passenger door. It is located on the same level as the glove box.
Left rear quarter near the axle.
It depends on the trim level of the 2005 Pontiac Montana because they take different sizes. See sources and related links below.
Apparently when its hot it should be higher than the cold level I read this in my owners manuel .. not very helpful..
When jacking up a 2000 Pontiac Montana to replace the front tire, the correct location for the jack is the reinforced jacking point located on the frame near the front wheels. This is typically just behind the front wheel well, where a small notch or mark may indicate the spot. Always ensure the vehicle is on a level surface, and use jack stands for added safety once it is lifted.
Refer to repair manual for proper instructions Remove gas tank remove sending unit replace with new sending unit and properly reinstall sending unit and gas tank
The sensor screws into the side of the oil pan. You will need to drain the oil and then replace the sensor.
yes
The "Low Coolant Sensor" on a 1997 Pontiac Montana is located appro 6" below the radiator cap which is on the left as your facing the engine. The sensor measures the fluid level in the radiator itself and is prone to giving false alarms when it gets dirty.
Go too eBay! Both should be less than 1K.
Its in the gas tank all part of the pump and fuel level sensing unit. Unless you have mechanical skill and some tools, may want to have the garage do this. Wont be cheap as the sending unit alone can cost upwards of $300 - $450 plus labor to put it in.