Look at it and you will figure it out.
How do you replace headlight bulb on 2004 Mazda Tribute?
Bulb is blown. Replace bulb.
To replace the rear tail light bulb on a Mazda MX-3, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull it out from the car. Twist the bulb socket counterclockwise to remove it, then replace the old bulb with a new one, ensuring it is securely in place. Finally, reassemble the tail light assembly and test the new bulb to ensure it works.
You have to pull off the front bumper 1st. Then after you pull off the front bumper, then you have to disconnect the whole light from the car. After that you can replace the bulb.
1997 Mazda 626 tail light bulb replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
To change that bulb push the bulb down and turn to take out you may need to unscrew the cover first and replace it with the same bulb
fuesed breaklamp replace bulb.
Very carefully
remve the tail light they are on the back side.
Open the trunk. Turn the socket counterclockwise and remove. Then gently pull out the light bulb. Place the new bulb in the socket and replace the socket into the lens by turning clockwise. Replacement light bulb #3652.
To change the marker light bulb in a Mazda Protege, first, open the hood and locate the light assembly. Remove the screws or clips securing the assembly and gently pull it out. Disconnect the wiring harness from the old bulb, twist the bulb socket counterclockwise to remove it, and replace it with a new bulb. Reconnect the wiring, reassemble the light assembly, and test the new bulb before closing the hood.