For a 98 S-10 Blazer, Tools: #2 Phillips screwdriver, a tool designed for interior door panel removal (a long flat screwdriver will work), metric socket set. 1. Pull back inside door handle, remove Phillips screw holding plastic trim piece on. Pull trim piece out, the right side of trim piece has plastic tab, pull to the left to disengage, rotate trim piece down while pulling out handle to remove. 2. Remove two bolts under arm rest using socket set. 3. Starting at top corner of interior door panel, pry back to release plastic panel clips. Work down and under panel to release clips. Do this carefully trying not to break clips. Lift up slightly after all clips are released to release panel from window slot. 4. Using socket set remove three nuts from bolts holding mirror to door. Pull out cable and unplug 5 pin connector. 5. Reverse directions to install new mirror. I did this in about an hour.
romove inside door panel, unfasten old,replace,plug in refasten new,replace doorpanel.
Your wording is a little tough but what you are asking is what the two blue wires are under the passenger seat. If the seats are heated, they would be the wires for the heater in the seat.
Engine Seized?
at passenger side in the smart box under the passenger's airbag.
If the heater still works the bulb is just burn out. I doubt you can change the light you will have to replace the switch.
The 1996 Ford Taurus heated oxygen sensor can be found behind the dashboard on the passenger side of the passenger compartment. The oxygen sensor should be labeled as such.
geothermal energyMost homes and factories in Iceland are powered by Geothermal energy. This is power extracted from the heat stored in the earth.
The balanced chemical equation for powdered quartz (SiO2) reacting with powdered magnesium (Mg) when heated is: 2Mg + SiO2 -> 2MgO + Si. This reaction produces magnesium oxide (MgO) and silicon (Si).
Once you find them there could be 3-4 usually 2 are under the passenger side 1 before the cat converter and 1 after them there should 1-2 more somewhere in the exhuast pipe that comes from the manifold on the drivers side.. As far as resetting them you can try unhooking the battery or buy yourself one of those mini code readers at a parts store....
yes you can, the auto tint feature is built into the glass, not power activated. the only thing i would look for is to make sure you hook the wiring up in the correct order. sorry, i meant check to see if the connectors look the same and the wiring coming off both connectors is the same color.
There are powered, heated mirrors that don't fog up at all, surprisingly!
it just means the trim-level. that it is leather seated and heated seats. LT is better than LS.