Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
How I can replace ignition switch cylinder from Isuzu Rodeo?.
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
Begin by removing the retaining ring at the top of your 1996 Chevrolet Silverado ignition lock cylinder. Slide the ignition lock out and remove the wiring harness. Reverse the process to install your new ignition lock cylinder.
Replace the ignition lock cylinder.
The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.
Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.
To remove the ignition lock cylinder from a 2004 Chevrolet Cavalier, first, disconnect the battery to ensure safety. Then, remove the steering column cover by unscrewing the screws securing it. Insert the ignition key and turn it to the "Run" position; look for a small pinhole on the ignition switch housing, insert a small tool to press the lock cylinder release pin, and pull out the cylinder. Finally, disconnect any wiring connected to the ignition switch if necessary.
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
To replace the ignition lock on a 1991 Oldsmobile Cutlass Ciera, start by disconnecting the negative battery cable to ensure safety. Remove the steering column covers to access the ignition lock cylinder. Insert the key into the ignition, turn it to the "Run" position, and locate the release tab or pin to remove the lock cylinder. Once released, replace it with a new ignition lock cylinder, reassemble the steering column covers, and reconnect the battery.
this is caused by ignition lock cylinder failure, you will have to replace the ignition lock cylinder and key.