To replace the low pressure switch on a 1997 Silverado AC, first, ensure the vehicle is off and the AC system is not pressurized. Disconnect the battery and locate the low pressure switch, typically found on the accumulator or the low side service port. Remove the electrical connector and unscrew the switch using a suitable socket or wrench. Install the new switch, reconnect the electrical connector, and restore power to the battery before testing the AC system.
It is screewed into the top of the engine block right behind the distributor.
you can have a professional do it.
No,, GM vehicles do not have an inertia switch.
how to change dimmer switch on 1997 Honda accord
how to clean evaporator on 1997 chevy 1500
About $150.00
The 1997 Pontiac Sunfire air conditioning low pressure switch can be found on the top of the air conditioning compressor. The low pressure switch will be labeled as the low pressure port.
To replace the evap emission system pressure sensor switch on a 1997 Nissan truck, first, disconnect the battery to ensure safety. Locate the pressure sensor switch, usually near the fuel tank or on the evap canister, and unplug the electrical connector. Remove the old switch using the appropriate tools, then install the new switch by screwing it in place and reconnecting the electrical connector. Finally, reconnect the battery and check for any leaks or issues with the evap system.
To gain some elbow room I would remove the distributor. That's how I do that one.
The 1997 Toyota Avalon air conditioning low pressure switch can be found on the top of the air conditioning compressor. The low pressure switch will be labeled as the low pressure port.
The oil pressure switch on a 1997 Chevy Blazer is located on the bottom of the engine, near the oil filter. It monitors the output and pressure of the oil pump.
The oil pressure switch on a 1997 Chevy Tahoe is located on the back of the engine. It is in the center-rear part of the engine.