0
they are connected at the rear of each wheel, and disconneted under the rear passenger seats and then lift flap under carpet and remove plastic lid, and they are both there, you have to lower petrol tank to remove sensor cable, and replace new ones. but i would leave if they are not faulty.
What else can I help you with?
How do you replace Peugeot 407 serpentine belt?
How do you replace peugeot 407 serprntine belt
Do I need a special tool to replace rear brake pads on a peugeot 407 2cc hdi 2006?
nope
How do you replace the multifunction display screen on a peugeot 407?
Replacing the malfunction display screen on a Peugeot 407 involves first removing the air conditioner control panel. This grants access to easily pop out and replace the lcd screen.
Where is fuse for brake light for Peugeot 407?
where is the fuses for a peugeot 407
Where does a peugeot 407 temperature sensor fit?
it is just under the drivers side mirror...a small bulb!!
Where is the tank for eolys fluid for peugeot 407 hdi?
under the fuel tank... near passenger side rear wheel.
Can you replace the tire pressure sensor valves for standard tire inflation valves on your Peugeot 407?
Yes, but they will no longer talk to the computer on board, this will mean that the little tire pressure warning light will probably stay on all the time.
When do you change timing belt on a Peugeot 407 hdi 16 valve?
when to chang timing belt on peugeot 407 hdi 1.6
How do you reprogram a lost keyfob for a Peugeot 407 sw 2007?
Procedure to reprogram a lost keyfob for a Peugeot 407 sw 2007
How much oil in Peugeot 407?
5.25l
Where is the coin compartment in the Peugeot 407?
in the trunk
How do you remove rear wiper arm from Peugeot 407 estate?
To remove the rear wiper arm from a Peugeot 407 estate, first, lift the wiper arm away from the rear window. Look for a small securing nut at the base of the arm and use a suitable socket or wrench to loosen and remove it. Once the nut is removed, gently wiggle the wiper arm to detach it from the splined shaft. Be cautious not to damage the shaft or the rear window during the process.
