disconnect battery, remove cruse lever, remove side cover , take pto (bolt from u-joint) unbolt engine from frame remove throttle and choke cable ,remove fuel line, unplug harness. remove engine, remove engine rear engine cover. starter bolts on here. takes about 5 hr. I may have missed a few steps , this is from memory a few years ago.
Most Small engines places sell them.
Remove the battery cable on the side of the starter. Then remove the two bolts holding it onto the engine. Once you have your new one just reverse those steps.
One can replace the drive belt on a Toro Lx 425 lawn tractor by reading their owners manual and learning how. A better approach may be to take the lawn tractor to an authorized Toro dealer to be fixed.
A141
form_title= Lawn Tractor form_header= Make lawn maintenance easy with a lawn tractor. Do you want to include a clipping bag?*= () Yes () No What is the square footage of your lawn?*= _ [50] Do you want a new or used tractor?*= () New () Used
Yes but you have to hook it to the mounting bolts. You will get just as good of a ground if you hook it to the frame of the tractor. Hope this helps.
For my Lawn tractor i just unscrewed the gas cap a bit and shook the rider back and forth with my hip. I had to replace my gas cap because the breathing function of it had worn out.
jump the starter solnoid, if it will crank , turn key on and jump again, if it starts then key switch is ok it would be the starter solnoid that's bad,
I own a 1995 LS45-16h
check your wiring harnes to your starter. make sure it is not connected backwards
10-30 motor oil
The ideal voltage for a lawn tractor battery is typically 12 volts.