0
There are two bolts you must turn to remove the old tension pulley. The one on the pulley must be loosened in order to loosen the tension pulley. To the left of the pulley(looking from the passenger side of the vehicle) the tensioning bolt is situated at a right angle to the pulley bolt. It is pointing towards the rear of the vehicle.
There is an aluminum slug inside the mount point for the pulley. You may have trouble threading the bolt back into the slug once removed. It is possible but you may have to hold the slug steady with the tensioning bolt.
Be sure to keep the aluminum brace that goes on the outside of the pulley. It will be hard to find if you lose it. Once the bolt holding the tensioner is removed from the engine the parts simply slip apart. Be sure to reassemble them just like you dissasembled them.
Tighten the bolt to the point that the pulley can still be adjusted with the tensioning bolt. Tighten the tensioning bolt until the belt is tight to specifications. then be sure to tighten down the pulley bolt.
What else can I help you with?
How do you reset the battery in a 1996 Chrysler Sebring?
There is no reset on a 1996 Chrysler Sebring.There is no reset on a 1996 Chrysler Sebring.
How much should it cost to replace the rack and pinion on a 1996 Chrysler Sebring?
It will cost between $300.00 to $500.00 to replace the rack and pinion on a 1996 Chrysler Sebring. This cost includes labor and parts.
How do you change the cam sensor on a 1996 Chrysler Sebring 2.5?
You have to buy and replace the entire distributor.
Where is the mass air flow sensor on a 1996 Chrysler sebring convertible?
A 1996 Chrysler Sebring does not have a mass airflow sensor.
How do you replace a door handle on a 1996 Chrysler Sebring?
You should be able to access after removing door panels
How do you replace the camshaft sensor on a Chrysler Sebring 1996 2.5l v6?
The cam sensor is part of the distributor. You have to replace the entire distributor.
The power steering pump on your 1996 Chrysler sebring is making a noise do I need to replace it?
Check the fluid first
How long should labor take to replace a water pump in a 1996 Chrysler Sebring Convertible?
6 hours
How do you replace the cam bearings on a 1996 Chrysler Sebring JXI with a 2.5L V6?
There are no replaceable camshaft bearings. You will need to replace the head or heads.
How do you change the alternator belt on a 1996 Chrysler Sebring?
To change the alternator belt on a 1996 Chrysler Sebring, first, disconnect the battery to ensure safety. Loosen the tensioner pulley by turning the tensioner bolt with a wrench, which will relieve tension on the belt. Remove the old belt, then install the new belt following the correct routing path as indicated on the engine's belt diagram. Finally, reapply tension to the belt by tightening the tensioner pulley and reconnect the battery.
How do you reset a fuel shut off switch on a 1996 Chrysler sebring coupe?
A Chrysler Sebring does not have a reset switch.
How much should it cost approxmately to replace a car distributor for a 1996 Chrysler sebring?
The part itself for that distributor $1000.00
