0
I have a 93 vic that I bought that had all 4 windows that would not operate. The regulators that raise and lower the windows were a cable operated type that were in good condition. Problem; the motors would run but would not operate the regulators. There was a clicking sound in the motors. I found out that there is a clutch type overload mechanism in the drive gear of the motors that was worn causing the slipage. Once the motor is removed a quick fix can be done. 1. Remove the small screw that holds the plate where the spline shaft comes thru. 2. If yours are like mine, there is a large bull gear made of plastic with a triangle shaped hole that the spline shaft rest in. 3. You might notice that there is room around the spline shaft that is void. 4. Place (3) about 1/4" balls from an old bearing down in these holes, grease & and re-assemble the drive motor. This acts as a pawl like on a pull rope start lawn mower and the spline shaft will turn the regulator. Notice that the drive motors will now stall in the top & bottm most positions but that is ok as long as you don't keep pressing the switch after the operation cycle. Its a quick fix that works......
What else can I help you with?
Picture instructions on replacing window regulator in 1998 crown Victoria XL?
need instructions on replacing window regulator
How do you repair the power window on a 1999 ford crown Victoria when the cable is all tangled up and window loose?
Cut the cables with a side cutters. Tape the window up until you can replace the regulator. The old one is toast
How to put a 1995 crown Victoria window on track?
You probably wont. Chances are, if your window doesn't go up and down right, you have a broken pulley in the window regulator assembly. This is common and requires the replacement of the window regulator.
Is the window regulator in a 1991 ford crown Victoria same as a 1992?
No, they are not the same. The body style changed in 1992.
92 Crown Victoria window goes up and down by hand and motor runs but won't raise or lower window Any idea how to fix?
You have a broken cable in the window regulator. You will need a new window regulator assembly.
Where is the fuel pressure regulator located on 1998 Crown Victoria 4.6?
Fuel pressure regulator located on 1998 crown Victoria 4.6 litter
Where is voltage regulator on 1996 Crown Victoria?
In the alternator
Where is the voltage regulator on 1996 Crown Victoria?
In the alternator
How do you install a Ford Crown Victoria window?
If it is a older Crown Victoria,( had to replace a window in 89 grand marq.) you have to take off the door panel to get to the window motor and i believe also there are some springs too, and put it on track. Isn't much of a answer you was looking for but it's a start...
How do you adjust the automatic window on your ford crown Victoria?
what year?
How do you replace fuel pressure regulator on 1985 crown Victoria?
To replace the fuel pressure regulator on a 1985 Crown Victoria, begin by relieving the fuel system pressure by removing the fuel pump relay and starting the engine until it stalls. Next, disconnect the battery and remove any components obstructing access to the regulator, typically located on the fuel rail. Unclip the vacuum line and disconnect the fuel lines from the regulator, then remove the mounting screws to take out the old regulator. Install the new regulator in reverse order, ensuring all connections are secure before reattaching the battery and testing the system for leaks.
Where is the 1992 Crown Victoria voltage regulator?
Its built into the alternator on all vics from 91 to current
