0
What else can I help you with?
How do you replace the fuel regulator on a 2000 Oldsmobile bravada 4.3 liter engine?
it is located inside the intake manifold
Does the head have to be removed to replace lifters in a 4.0 liter jeep engine?
i dont think they do, the lifters are right under the intake manifold
Knock sensor location 05 5.3 liter Chevrolet silverado?
There is 2 of them and thay are under the intake manifold. You will have to remove intake manifold to get to them.
Where is the PCV valve located on a 2005 Mazda 6i with a 2.3 liter?
It is located under the Intake Manifold. You must remove the intake manifold to get to it.
WhyEngine coolant in crankcase 5.7 liter vortec?
That is a very COMMON PROBLEM WITH those engines. You need to replace the intake manifold gaskets to fix that problem.
How do i stop 5.7 liter intake gasket leak?
You will have to remove the intake manifold and install a new intake gasket. You have no choice.
Where is the knock sensor located on a 1999 Chevy 5.3 liter engine in a silverado?
There is two of them. They are located under the intake manifold. There is two of them. They are located under the intake manifold.
Replace head gasket in 1997 buick 3.8 liter?
Head gaskets do not go bad on these. You need to replace the plastic upper intake manifold as it is leaking coolant into the combustion chamber. Common problem for this engine.
Where is the PVC valve located on a 1986 5 liter Mustang GT with fuel injection?
in lower intake Manifold at the back, also replace breather filter under the PCV.
Where is the map sensor located on a 3.2 liter intrepid?
On the intake manifold on the driver side.
Where exactly is the intake gasket located on a 1998 olds achieva 3.1 liter engine?
directly under the intake manifold
Where is engine temperature sensor located on 3.8 liter 1990 ford thunderbird?
The engine temperature sensor on a 1990 Ford Thunderbird with a 3.8-liter engine is typically located near the thermostat housing, which is on the front of the engine. It is usually positioned on the intake manifold or cylinder head. To access it, you may need to remove any obstructions, such as the air intake or other components, depending on the specific setup of your vehicle. Always consult a repair manual for precise details and safety precautions.
