answersLogoWhite

0

Since the O2 sensor is located on the exhaust manifold, when its cold, it may be difficult to remove. Start and run engine for a minute or two, but be careful not to burn yourself. from underneath, disconnect the electrical connector from the sensor. Unscrewe the sensor from exhaust manifold. they do sell a special socket for this job. If you are using the old sensor, make sure you use anti-seize on the threads whereas a new one should already have it. Install and tighten securely. Reconnect electrical connector. Test drive and make sure no trouble codes set.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the oxygen sensor in a 1985 Chevy Camaro?

somewhere


How do you replace an oxygen sensor on a 94 Chevy Suburban?

Just unplug the electrical connector and then unscrew the oxygen sensor out of the exhaust pipe.


How do you repair an oxygen sensor for a 2001 Chevy Malibu?

You can't repair an o2 sensor,You'll half to replace it


Does a 1995 Chevy Camaro Z28 have a crank sensor?

No it does not


Camaro 1999 z28 crank position sensor?

how do you change a crankshaft position sensor on a 1999 chevy camaro z28?


How do you replace an oxygen sensor on a 2001 Chevy Impala?

There is 1 before and 1 after the catalytic converter.


How do you replace oxygen sensor on 07 Chevy Colorado?

To replace the oxygen sensor on a 2007 Chevy Colorado, first, ensure the vehicle is turned off and cooled down. Locate the oxygen sensor, which is typically found on the exhaust manifold or the exhaust pipe. Disconnect the wiring harness from the sensor and use an oxygen sensor socket or wrench to unscrew it. Install the new sensor by threading it into place, reconnect the wiring harness, and start the vehicle to check for proper operation.


How do you replace a water pump on a 1996 Chevy Camaro z28?

How can do I replace a water pump on a 96 camaro z28


Where is the Bank 1 Sensor 1 on Chevy Suburban LT1500 to replace Oxygen sensor?

driver side bank 1 before cat


How do you unplug an oxygen sensor on a 2003 Chevy Cavalier?

How do you unplug an oxygen sensor on a 2003 Chevy Cavalier


How do you change oxygen sensor on a 2006 Chevy aveo?

How do you change oxygen sensor on a 2006 Chevy aveo?"


How do you replace the oxygen sensor on a 2000 3.8 liter Chevy camaro?

It requires a special socket that is slotted up one side so as not to damage the wiring. The cost of the socket is quite high and will not justify the purchase unless you plan on using it often.