0
This is not an easy or cheap job... It requires removal of the cylinder head, this basically means taking off the top half of the engine!
you will need to drain oil and coolant, undo all sensors to cylinder head, disconnect exhaust from head, remove timing belt etc.
once you get the head off you need a valve spring compressor to squash each spring and remove the collect's that hold each valve in place.
You need to lap in each new valve before carefully rebuilding the head with new valve seals.
Then you need to put the whole engine back together again with new gaskets and sealants and new head bolts.
I would also advise a new coolant thermostat, timing belt and timing belt tensioner. Possibly also a new water pump. As if these go faulty it could mean you bend your new valves.
new oil & oil filter, and new coolant.
Not a job for a novice or for the faint hearted!
What else can I help you with?
What needs to be done to repair bent valves?
Replace the bent valves and inspect the pistons & head for damage. Replace and repair as necessary any defective parts.
Do you have to replace the valves if your belt is broken on a 2006 Chrysler pt cruiser?
If they are bent, yes.If they are bent, yes.
How do you repair bent valves in a 1.8T AWP engine?
Replace the bent valves with new ones. Several places carry them. Be prepared it is a very in depth job. Be sure to check the pistons to make sure they aren't too damaged from the valves coming into contact with them.
What do you do if the timing belt breaks on a 1993 300ZX?
Replace the timing belt and pray that you dont have bent valves.
What happens when timing belt breaks on a 2004 dodge neon?
Bent valvesBent valves
Do you have to change the timing belt if you replace the water pump on a 1995 chrysler cirrus?
No, but it is recommended. If the belt breaks, valves can get bent.
What are possible causes for bent valves?
One of the most common reasons for bent valves is a broken timing chain or belt.
What causes a bent valve?
The main cause for bent valves is a failure in the timing chain or belt. When the valves and pistons are not exactly in sync, they can collide.
Do you need to have the valves changed when the timing belt breaks?
If the valves bent, then yes.
How much does it cost to replace the timing belt on a 2002 Nissan Pathfiner?
if it broke it could cost you several $g's probly bent the valves too
Will the valves on a corsa utility get bent if the cambelt cuts?
Yes, if the cambelt on a Corsa Utility fails or cuts, it can lead to bent valves. This is because the engine's pistons may collide with the open valves when the belt breaks, particularly in interference engines where the piston and valve paths occupy the same space. It's essential to replace the cambelt at recommended intervals to prevent such damage.
Can you find out if your pistons hit your valves when the timing belt snaps or do you have to put new timing belt on first?
You can do a cylinder leakage test to check for bent valves.You can do a cylinder leakage test to check for bent valves.
