answersLogoWhite

0

My Haynes manual says this is how it's done. Open the trunk On early models, detach the trim panel and remove the nuts holding the light housing in place, then withdraw the housing from the vehicle On later models, the light housing runs the full width of the vehicle. Remove the nuts securing the taillight panel to the body. Pull the taillight panel out. On all models, rotate the bulb holder(s) 1/8-turn counterclockwise and pull it out of the housing, then pull the bulb out.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace a 3rd brake light on a Cadillac CTS?

To replace the 3rd brake light on a Cadillac CTS, first, open the trunk and locate the access panel or the area where the brake light is installed. Remove any screws or clips securing the light assembly and gently pull it out. Disconnect the wiring harness from the old light, replace it with the new one, and reassemble the light assembly by securing it back in place. Finally, test the brake light to ensure it is functioning properly.


Why do the brake lights stay on in your 1998 Cadillac Catera?

you need to replace the brake light button under the brakes inside the car


1998 dodge 3500 ram passenger blinker light will not flash and brake light will not work?

REPLACE THE BULB


How much does it cost to replace a brake light bulb on cadillac cts?

a buck for the bulb and 2-3 minutes of your time to replace it


How do you replace a brake light bulb on a 2007 Cadillac CTS?

The brake light bulb on a 2007 Cadillac CTS can be replaced by opening the truck, removing the rear cover, and disconnecting the wiring harness. The bulb can then be twisted, removed, and a new bulb put in its place.


How do you replace brake lights in brake bar of Cadillac 2006 dts?

To replace the brake lights in the brake bar of a 2006 Cadillac DTS, first, open the trunk and remove the access panel or cover on the side of the brake light assembly. Next, twist the bulb socket counterclockwise to remove it, then take out the old bulb and replace it with a new one. Reinsert the socket back into the assembly, ensuring it locks into place, and finally, replace the access panel. Test the brake lights to confirm they are functioning properly.


How do you replace the rear passenger brake light in a 1998 Chevrolet Malibu?

go into your trunk and you will see little black tabs on the inside un screw those tabs the brake light will then pop right out...


When did cadillac introduce the third brake light?

1985


How do you reset the Change Brake Pads Soon light on a 2001 Cadillac Seville?

The senors need to be replaced, they are about $75.00 a piece and there are 4. Even if you replace the brakes; until replace the senors it will is flash change brake pads on dashboard


How do you replace the third brake light on a 2002 Cadillac Escalade?

To replace the third brake light on a 2002 Cadillac Escalade, first, lift the rear hatch and locate the screws or clips securing the light assembly. Remove these fasteners, then gently pull the light assembly away from the vehicle. Disconnect the electrical connector, replace the old bulb with a new one, reconnect the assembly, and secure it back in place with the screws or clips. Finally, test the light to ensure it’s functioning properly.


How do you replace the Brake light on a 2000 ford explorer?

To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.


How do you replace brake light on Nissan tiida?

How to replace a brake light on a nissan Tiida hatch back.