This is very easy if you are mechanically inclined you will need a steering wheel puller. You will need to pull the cover off the steering column by removing four phillip screws under the column and the dash cover under the column by removing 3 9/32 screws. You'll need a 10mm socket to remove the air bag it has 4 nuts that hold it on the back side of the steering wheel next you'll unplug the air bag and horn then remove the 16mm nut holding the steering wheel then use the puller to remove the steering wheel. You'll see 3 screws on a black disk that's the clock spring. remove the screws and unplug the wires connectors under the dash. pull the wires and clock spring up through the top of the column. to install just reverse the process.
Please make sure you disconnect the battery and wait at least 30 minutes to an hour or more. You see, the air bag circuit ( called SRS in Ford manual) has backup power in the form of charged capacitors, it takes about 20 minutes to discharge once battery is disconnected. If you don't take this step before clock spring replacement there is a chance of air bag deploying while you are removing it from steering wheel.
Huh?
replace ford fiesta clock
To replace the rear coil springs on a 1996 Ford Aerostar, first, safely elevate the vehicle and support it with jack stands. Remove the rear wheels, then detach the shocks and the lower control arm to allow for suspension movement. Use a spring compressor to safely compress the old coil springs, then remove them from the control arm and install the new ones. Finally, reassemble the suspension components, ensuring everything is properly torqued before lowering the vehicle back to the ground.
What exactly do you want to know about "Air conditioning clutch on a 94 ford aerostar van?" How to replace? What engine do you have, etc.?
Electric or manual?
Ford Aerostar was created in 1986.
What type of rear end do you have?
Autozone worked very well for me on my 91' Aerostar 3.0 .
Hi There, I have a factory tape deck in mine and the clock on it is changed by holding down the "clock" button and pushing seek (right) for minutes and seek (left) for hours.
Yes they are compatible
How do you remove the rotors on a 1992 ford aerostar?"
I replace alot of ignition switches in these things. And clock springs.