through the reserve tank which is also called the overflow tank being that there is no radiator cap!
We have a 1998 V8 Olds Aurora, and it takes dex-cool engine coolant. It is the coolant that is orange colored. Wouldn't your small manual tell you the correct coolant to use?
its located under the reserve tank...and if that is not working and you are for sure the you will have to replace the whole tank by dealer or maybe find on-line somewhere!
red coolant use the dexcool
1998 olds aurora altenator replcemnt
The coolant temperature sensor on a 1998 Oldsmobile Aurora is typically located near the thermostat housing, on the engine block. It's usually situated on the driver's side, towards the front of the engine. You may need to remove some components for better access, depending on the engine configuration. Always consult a repair manual for specific details and diagrams related to your vehicle.
To replace the engine coolant in a 1998 Volkswagen Polo, first ensure the engine is cool and then locate the coolant reservoir. Drain the old coolant by opening the drain plug at the bottom of the radiator or removing the lower radiator hose. After draining, close the drain plug, refill the system with a suitable coolant mixture, and run the engine with the heater on to help eliminate air pockets. Finally, check the coolant level and pressure test the system for leaks.
Trouble code P0118 means: Engine Coolant Temperature Circuit High Input Replace the coolant temp sensor
On a 1998 Lincoln Continental : The thread on cap on your engine coolant reservoir is the pressure cap / radiator cap . The engine coolant reservoir is in your engine compartment , towards the passenger side of the engine compartment
Should be located in a removable housing at the engine end of the upper radiator hose Is at lower radiator hose, not upper Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Reinstall housing Re-fill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
To add coolant to a 1998 BMW 740i, locate the coolant reservoir, which is typically found near the front of the engine bay on the driver's side. Remove the cap from the reservoir, and pour in the appropriate coolant mixture, ensuring you do not overfill it. Always check the engine temperature and allow it to cool before adding coolant to prevent any injuries or damage. After refilling, replace the cap securely.
On my 1998 Aurora with a 4.0L V8, the water pump is on the driver's side of the engine. It is right at the top of the engine.
Tha alternator on this car car is very hard to see and to get to to replace. On the front of engine, down low between the radiator and engine, above the A/C compressor.- techJK ----------------------------------------