To replace the front brakes on a 1989 Plymouth Acclaim, start by safely lifting the vehicle and removing the front wheels. Next, remove the brake caliper by unbolting it and then slide it off the brake rotor, supporting it with a bungee cord or hanging it to avoid stress on the brake line. Replace the old brake pads with new ones, ensuring they fit properly, and reassemble the caliper. Finally, reattach the wheel, lower the vehicle, and pump the brake pedal to restore brake pressure before testing.
look at it and see.it will be obvious.,most have disc front and drum rear...if not all of them,,,
remove them greese them up if that dont work replace seals or buy new ones
The 1990 uses a t50. The 89 is probably the same.
Changing brakes is simple. Lift the car, remove the tire, remove the brake shoe, remove the old brake pad, replace it with a new brake pad, return the brake shoe, replace the wheel and lower the car.
The fuel filter is on a front corner of the fuel tank.
yo im workin on that s*** right now its such a b**** puttin the calipers back on. ill get back to you if i find out.
Plymouth Acclaim was created in 1989.
Its time to replace it.
Sounds like you need to replace your Calipers at at least one of them if both are not heating up. The piton in the caniper is likely siezed common problem on any vehicle.
in the gas tank..
1989 Honda Civic models did not come with ABS. The car was a smaller compact hatchback and used basic front disk brakes with rear drums.
Depends on the engine