I own 2003 Tracker 4x4 4 cyl.
My crossmember is rusted out and the dealer will replaced- no cost to me.
But I have question: if the crossmember is out - will be easy to replace the oil pan and starter ? any saving for me?
Mark
Yes, the cross member is under the load on a 1989 Chevy van.
Replace
It is on the inside of the frame rail by the cross member on the driverside.
ON THE FRONT CROSS MEMBER BETWEEN THE WHEELS.
It will be on the back of the transmission where the drive shaft goes in, and bolted to the cross member
The location of the battery on a Chevy Venture is under the hood. It rests under the cross bar, which has to be removed to replace the battery.
Cross member
It taps into your bell housing, behind where the motor meets the tranny, it is right above your cross member, you can remove the cross member and get to it very easily, you do not have to remove it to replace it though
Yes but you will have to change the Trans and also add Chevy motort mount brackest to the cross member.
To replace the radiator cross member on a 2007 Kia Spectra, first, disconnect the battery and remove any components obstructing access, such as the front bumper and radiator. Support the radiator with straps or a stand to prevent it from dropping. Remove the bolts securing the cross member and carefully detach it. Finally, install the new cross member by reversing the disassembly steps, ensuring all bolts are tightened properly and reconnect any components you removed.
It is up in the driverside frame rail back by the transmission cross member.
It is up inside the driverside frame rail, back by the transmission cross member.