remove the a piller trim, they just pull off remove the black trim which goes across below the windshild with a short screw driver remove the screws from the speaker unplug the wire connector put in the new speaker
Using a flat blade screwdriver, gently pry up bottom of speaker grill.
4x6 in the front dash
4" in front dash
Remove the right pillar cover. Once removed slide a flat head screw driver carefully between the cover that holds the speaker and the dash cover. You will see 2 separate covers. Pry open slowly from the right side up. You will be able to use your hands. The speaker is held in with screws. I never took my out just unplugged it. Be careful with the windshield when you remove the speaker. Hope this helps How do you replace the front dash center speaker of a 2000 dodge intrepid es that has the factory infinity system?
5x7 in the back dash 3 1/2 in front dash
if a t/a came with front speaker it was mounted in the dash facing the windshield
The front and back speakers are 6x9, there are also speaker holes in the front dash on the left and right. The dash speaker holes are small, like 3 1/2 or 4 inch.
To change the front dash speakers in a 1991 Cadillac Fleetwood, start by carefully prying off the dash cover to access the speaker area. Remove the screws or clips holding the speakers in place, then gently disconnect the speaker wires. Install the new speakers by connecting the wires and securing them with the screws or clips, then replace the dash cover. Ensure everything is properly aligned and secure before completing the installation.
4"
The largest speaker that will fit in the dash is a 4"x6". Not sure what the exact dimensions are on the OEM speaker. front speakers are 4x6 and the rear or 6x9
Open front passenger door and you will see fuse box labeled on dash board. Between door and dash board.
You have to remove the whole dashboard and then the speaker should be exposed, then just remove it.