0
Jack up the vehicle and put a safety stand under it. Take the wheel off. With a hammer hit the stud on the tip, several blows should knock it loose. The stud can be pulled out from the rear. Slide a new stud into place, and put to two or three washers on it. thread the nut on, then tighten it. The nut will pull the stud in tight. Remove the nut and washers, then remount the wheel.
What else can I help you with?
How do you replace front wheel bearing on 1996 Hyundai Elantra?
how to replace front wheel bearing on 1996 Hyundai elentra
Cost to replace front wheel bearings 1996 corolla?
In San Francisco, CA the Kragen auto parts sold me the wheel bearing for $31.99.
How do you replace the front wheel bearing on a 1996 mercury villager?
The front wheel bearings must be pressed into and out of the spindle/hub assembly. You will need to take the spindle assembly to an automotive machine shop to have this done.
Is the 1996 Chevy Lumina front wheel drive or rear wheel drive?
Front-wheel drive.
How do you replace a 1996 grand prix front bumper?
How do you replace a 1996 Grand Prix front bumper?
1996 Monte Carlo front or rear wheel drive?
front wheel drive
Where is the speed sensor on a 4-wheel drive 1996 suburban?
It is screewed into the transfur case.
How many lug nuts does a 1996 4x4 suburban have?
should have six per wheel
Is your 1996 Honda accord lx a front wheel drive or rear wheel drive?
front wheel drive
Is 1996 Honda Civic a front wheel drive or rear wheel drive?
A Honda Civic is front wheel drive
Is a 1996 mustang front wheel drive?
No , rear wheel drive
How do you replace front wheel bearing 1996 Nissan 200sx?
To replace the front wheel bearing on a 1996 Nissan 200SX, start by safely lifting the vehicle and removing the front wheel. Then, take off the brake caliper and rotor to access the wheel hub. Use a socket to remove the hub assembly, and then press out the old bearing using a bearing puller or a hydraulic press. Install the new bearing into the hub, reassemble the components in reverse order, and ensure everything is torqued to the manufacturer's specifications.
