Take the tank down the pump is placed inside the tank on the top of the tank
You would have to have the engine and transmission wiring harness and fuel pump harness. And you would have to install an electric fuel pump that will pump No lower then 9 LBS. and NO higher then 13 LBS. in the fuel tank. You will also have to get and install a ECM / ENGINE CONTROL MODULE / COMPUTER IN THE TRUCK. Basically you will need alll the ELECTRONICS FROM the 1994 and install all of it in the 85 truck and you will have a NICE ride. GOOD LUCK
in the gas tank if it is throttle body, under the driverside door on the frame if carbed
On a 1995 Chevy C20 truck, the fuel injectors are fired by the engine control module (ECM). The ECM sends a signal to the fuel injectors based on inputs from various sensors, such as the throttle position sensor and the mass airflow sensor, to determine the optimal fuel delivery for engine performance. This process ensures that the right amount of fuel is injected into the engine at the correct time for efficient combustion.
Absolutely.
Yes, but you'll need V8 motor mounts and exhaust. Probably should have a bigger radiator also.
C20 was Chevy's designation for a 3/4 ton. 2500 was GMC's designation for a 3/4 ton. Basically they are the same.
SAE 10W30
Yes.
134 freon
from a library
3/4 ton.
Might say on title