answersLogoWhite

0

Hi, If I'm not mistaken, there should be a very small pin hole just below where you insert the ign. key.. What you do is take a paper clip and insert it into that small hole when you have the ign. key in the accessories position, and you should be able to pull that whole key & tumbler piece out!

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace a 1970 Chevy Nova ignition switch?

To replace the ignition switch in a 1970 Chevy Nova, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing any screws or bolts, then locate the ignition switch, which is usually mounted on the column. Detach the wiring harness from the old switch, unscrew it from its mounting position, and install the new switch in reverse order. Finally, reconnect the battery and test the new ignition switch to ensure it functions properly.


Change ignition lock on 1970 ford maverick?

How do I replace an Ignition in a 1970 Maverick


How do you replace the key ignition switch in a 1970 Chevelle SS?

several special tools are REQUIRED to perform this task, which involves removing the steering wheel.


How do you remove ignition switch from a 1970 Chevelle steering column?

To remove the ignition switch from a 1970 Chevelle steering column, first ensure the battery is disconnected for safety. Then, remove the steering wheel, and disassemble the column cover to access the ignition switch. Locate the switch at the base of the column, disconnect the wiring harness, and remove any screws or bolts securing the switch in place. Finally, carefully pull the ignition switch out of the column.


How do you remove ignition switch 1970 Pontiac gto?

To remove the ignition switch from a 1970 Pontiac GTO, first disconnect the battery to ensure safety. Then, remove the steering column cover by taking out the screws or bolts securing it. Locate the ignition switch, disconnect the wiring harness, and unscrew the switch from its mounting position. Finally, pull the switch out carefully from the steering column.


1970 Chevrolet high speed blower switch not working?

replace the switch.


How do you replace the headlight switch on a 1970 Chevelle Malibu?

any pictures of headlight switch replacement of 1970 chevelle ss


1970 camaro you have power to the dist with key on but you loose it when cranking the key?

change the ignition switch.


How do you replace a headlight switch on a 1970 Buick Electra?

To replace the headlight switch on a 1970 Buick Electra, first disconnect the battery to ensure safety. Remove the dashboard trim panel to access the switch, then unscrew and disconnect the wiring harness from the old switch. Install the new headlight switch by connecting the wiring harness and securing it with screws before reassembling the dashboard trim and reconnecting the battery. Test the new switch to ensure it functions properly.


How do you replace the ignition switch located on a 1971 Chevy El Camino with tilt steering?

The ignition switch is located on the steering column just above the brake pedal. it has 2 screws holding it in place. You will need to take the entire steering colum off. Pull the wiring harness out.. it's a real pain. I own a 1970 SS 396 cowl induction, factory air, everything stock. It's an orignal. == == Your car has a Rack and rod setup. When the key is turned it pushes the rod down the steering column and slides the ignition switch into the position you want. To replace it you need to remove it from the bottom of the steering column. There should be either two screws or a clamp.


First ignition switch in the steering column?

The first Column ignitions switch was introduced on GM cars in 1968 for the 1969 Model year...Ford and Chrysler introduced it in 1969 for the 1970 model year..


When was MSD Ignition created?

MSD Ignition was created in 1970.