0
According to the manual that I have for my 86 Bronco II, it says this: Removal- Rotate the lock cylinder key to the Lock position. Disconnect the negative battery cable from the battery. For tilt column only, remove the upper extension shroud by squeezing it at the 6 and 12 o'clock positions and popping it free of the retaining plate at the 3 o'clock position. Remove the 2 trim shroud halves by removing the 2 attaching screws. Disconnect the ignition switch electrical connector. Drill out the break-off head bolts connecting the switch to the lock cylinder housing by using a 1/8 in. (3mm) drill bit. Remove the 2 bolts, using an Ex-3 Easy-out tool or equivalent. Disengage the ignition switch from the actuator pin. ----------------------------------------------------------------------------------- To install- Rotate the ignition key to the RUN position, approximatly 90 degrees clockwise from LOCK. Install the replacement switch by aligning the holes on the switch casting base with the holes in the lock cylinder housing. Note that the replacement switch is provided in the RUN position. Minor movement of the lock cylinder to align the actuator pin with the U-shaped slot in the switch carrier may be required. Install the new break-off head bolts and tighten untilheads shear off (approx. 35-50 in. lbs.). Connect the electrical connector to the ignition switch. Connect the negative battery cable to the battery terminal. Check the ignition switch for proper operation in all modes. Install the sterring column trim shrouds.
What else can I help you with?
What is the best 2008 Suv to replace a full sized Ford Bronco?
my 86 full size bronco haha
How do you replace ball joints on a 1996 Bronco 2?
You must mean 86 Bronco II? There is no 96 model.
Where is the rollover switch located on a 1990 bronco?
i beleave the inertia switch is located behind the glove box or just below it.. that's where it is located on my 86 and my old 88 bronco II
Will an 86 bronco top fit an 84 bronco?
yes
How do you replace dimmer switch 86 elcamino?
To replace the dimmer switch in an 86 El Camino, you'll need to locate the switch located on the floorboard near the driver's left foot. Disconnect the electrical connector, unscrew the old switch, replace it with a new one, and reconnect the electrical connector. Test the new switch to ensure it's working properly.
Will the rear seat from a 86 bronco fit in a 89 bronco?
yes
On a 86 full size bronco is tailgate dash switch hot at all times?
It shouldn't be. It was designed to only operate once the key was turned on.
Is a 84 bronco able to change parts with a 86 bronco?
yes most everything
WHY when I park my 86 Bronco 2 nose downhill does the oil pan fill up with Gas and THE car will barely run at any RPM...?
Replace fuel pressure regulator.
How do you replace 86 bronco distributor?
To replace the distributor in an '86 Bronco, first disconnect the battery and remove any components obstructing access to the distributor. Mark the position of the old distributor for proper alignment, then remove the ignition wires and the hold-down clamp. Lift out the old distributor and install the new one, ensuring it aligns with the marks you made earlier. Finally, reconnect the ignition wires, reassemble any removed components, and reconnect the battery.
Will door window on 87 f150 fit 86 bronco?
it most certianly will!
Where is interia switch 86 bronco 2?
The inertia switch in a 1986 Ford Bronco II is typically located behind the right side of the dashboard, near the passenger footwell. It may also be found in the engine compartment, near the driver's side fender. This switch is designed to cut off fuel to the engine in the event of an accident, helping to prevent fires. Always consult the vehicle's service manual for the exact location and instructions.
