Remove the instrument cluster then replace the bulbs. = =
You have to remove the instrument cluster to get access to the bulbs.
There are no individual bulbs, just LED's in the dials, and you will have to replace the entire instrument cluster.
You take out the cluster and replace the bulbs in the back of the cluster. Very simple job, takes baout 10 mins!
The instrument cluster needs to be removed to get at the bulbs.
The instrument cluster must be removed to replace the light bulbs on it.
To replace the instrument light bulbs in a Jaguar XJ8, first, ensure the ignition is off and disconnect the battery for safety. Carefully remove the instrument cluster by unscrewing it from the dashboard and gently pulling it out. Locate the faulty bulbs, twist them counterclockwise to remove, and replace them with new bulbs. Finally, reassemble the cluster, reconnect the battery, and test the lights to ensure they work properly.
an acura is an American car and get a new car
You have to remove the instrument cluster to service the light bulbs.
Remove the instrument cluster and replace the bad bulbs. Take the battery cables off!Remove the upper and lower steering colum covers. Remove the four screws on the cover. Tke the screws out of the cluster and turn it over. Replace the bad bulbs. Had to replace the whole cluster on mine as the speedometer and the heat guage were kaput!
Below the instrument cluster is a trim piece that goes across the width of the instrument cluster. Remove the 4 screws then remove the trim piece. Remove the screws that retain the instrument cluster, then carefully pull the instrument cluster STRAIGHT BACK. The instrument cluster plugs in to a matching socket in the dashboard. Be certain that the pins do not get bent. It's a good idea to replace all of the bulbs once one burns out. The rest will be failing soon. There are two types of bulbs used in the dashboard, they might only be available at a GM dealership. Replace all of the bulbs. Carefully push the instrument cluster back into the dashboard, then test the lights and make certain that the instruments and indicator lights work before putting everything else back together. Replace the trim ring around the instrument cluster. Replace the bottom trim piece... Done. ... at least, that's how it works on the 2000 LS
You have a light out...take a look at the trim around the instrument cluster, should be held in by a few screws. After pulling the cover pull the cluster, look on the back, check all bulbs and replace the ones that are burnt out or replace them all. You have a light out...take a look at the trim around the instrument cluster, should be held in by a few screws. After pulling the cover pull the cluster, look on the back, check all bulbs and replace the ones that are burnt out or replace them all.