answersLogoWhite

0

take all the plastic bits off of it, pull up and out on the cluster, unhook the wires and tubes, swap out the new gauge cluster and put it all back together

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How can you calibrate the gauges on the instrument panel after removing needles on a 1994 Camaro Z-28?

You can't and will have to buy new ones or replace the instrument panel with a used one.


Where is the instrument panel relay on a 1994 ford escort?

Where is the instrument panel relay located on a 1994 ford escort


How do you replace the instrument panel lights in the 1994 Buick Regal?

To replace the instrument panel lights in a 1994 Buick Regal, first ensure the vehicle is off and disconnect the negative battery cable for safety. Remove the instrument panel by unscrewing the screws that secure it, then carefully pull it out to access the bulb sockets. Twist the bulb sockets counterclockwise to remove them, replace the old bulbs with new ones, reassemble the panel, and reconnect the battery cable. Finally, test the lights to ensure they are functioning properly.


All gauges on 1994 olds cutlass supreme do not work what do you replace dash or wires?

check the fuses first, there should b a fuse for the instrument panel check the fuses first, there should b a fuse for the instrument panel


What year dodge instrument panel will interchange with a 1995 dodge ram 1500?

1994


Where is the EEC located on a 1994 bronco?

Most computors are located behind the passenger side kick panel. That's the panel to the right of your feet while sitting in the pass seat.


How do you change the rear main seal on a 1994 ford bronco?

Remove transmission and replace the rear main seal


Where is the location of the PCM on a 1994 ford bronco?

The Powertrain Control Module (PCM) on a 1994 Ford Bronco is typically located behind the passenger side kick panel, near the footwell area. To access it, you may need to remove the kick panel and possibly some trim pieces. The PCM is a rectangular box with a connector harness attached to it.


Where and how do you change the flasher on 1994 Ford Bronco?

To change the flasher on a 1994 Ford Bronco, locate the flasher relay under the dashboard, typically near the steering column or behind the fuse panel. It’s a cylindrical component that can be pulled out of its socket. Replace it with a new flasher by pushing it firmly into the socket until it clicks into place. Always ensure the vehicle is turned off before replacing the flasher for safety.


Which fuse is for the instrument panel in a 1994 Altima?

The fuse for the instrument panel on a 1994 Altima is the second one up from the bottom on the left row of fuses it says electronic parts and it controls the tachometer, temp gage, fuel gage and the overdrive. It is a 10 amp fuse.


Where is located the fuse for the dashboard lights in the 1994 Mercury Villager?

That is in the fuse panel inside the car. Marked I/P illum (instrument panel illumination)


Vacuum hose diagram for 1994 ford bronco?

vacuum hose dimgram for 1994 ford bronco