answersLogoWhite

0

Unplug the electrical connector and slide the OIL SENDING UNIT SOCKET down over it and screw it out. It is a special socket. If you have the room you can screw it out with a pair of pliers.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where does the hot wire lead to from the sending unit on a 1986 Chevy s-10 pickup?

Which sending unit? Oil pressure sending unit? Engine temp sending unit? Fuel gauge sending unit?


How do you replace a CV joint on a 1992 Chevy pickup?

how do you replace a CV joint on a 1992 Chevy pickup?


How do you replace sending unit 1994 Chevy 1500 5.7?

We need to know which sending unit you speak of. There are several on that vehicle such as temperature sending unit, oil pressure sending unit and fuel gauge sending unit.


Where is the oil pressure switch is located at in a Chevy 4.8 1999 Chevy pickup?

The Oil Pressure Switch is located on the driver's side top rear of the engine on your Chevy Pickup.


How do you replace power steering hose on a Chevy c-1500 pickup truck?

how do replace a power steering hose on a Chevy c-1500 pickup truck


How do you replace sending unit on a 2006 Chevy Malibu?

Need to know which sending unit you want to replace, there are several.


How do you replace a starter in a Chevy pickup?

What year,what motor?? it is a 2002 Chevy avalanche 1500


Why is my oil gauge maxed out on your 2006 Chevy?

You oil pressure sending unit is more than likely defective. Replace it with a new one.


How do you replace a control moguel on a Chevy 97 z71?

o you replace the 97 .5.7 chevy pickup control moguel


How do I replace a fuel sending unit in a 1990 Chevy pick up truck?

on mine i had the option of dropping the fuel tank or movink th pickup bed 2 feet back


92 Chevy replace oil pump?

what would cause a oil pressure gauge to fluctuate on my 99 Chevy truck silverado i change the sending unit it does it mostly after it warmed up


How do you replace the Engine Oil Pressure Gage Sensor on a 1994 Chevy Pickup?

This requires a special socket to fit the sending unit. Using pliers may damage the unit and cause an oil leak. The unit is located in back of the engine , on top, just to the drivers side of the distributor.