it depends on if the mirror is electric or not if it is then take the door panel off and then take the screws out of the mirror and the disconnect the wiring and the do the reverse to put new one on. if its not electrical the do the same except you don't have to unhook the wiring.
To replace the passenger side mirror on a 1997 S10 Blazer, start by removing the interior door panel to access the mirror mounting screws. Disconnect any electrical connectors if the mirror is powered. Unscrew the old mirror from the door and replace it with the new one, securing it with the screws. Finally, reattach the door panel and reconnect any electrical components.
on mine i had to take the door panel off to get to the bolts, after that its easy
how to replace a heater core in a 1997 Chevy blazer
Take the door panel off and there are 3 screws holding it on.
The 1997 Chevrolet blazer modulator valve is located on the firewall in the engine compartment. The valve will be on the passenger side of the firewall.
on a 1997 blazer, how to remove drivers side mirror under your handle to close the door is two 7mm bolt and behind your handle to open the door is a Philips screw and that plate behind it comes off then CAREFULLY remove the door panel trust me you don't want to break the plastic then you will see your mirror bolts and electrical wiring
The 1997 Chevrolet blazer actuator switch is located on the firewall in the engine compartment. The switch is on the passenger side of the engine compartment.
Drop the fuel tank.
twist it out and twist in the new one or you can just replace the mirror
The average cost to replace your 1997 Chevrolet Blazer water pump is $230. The water pump will cost approximately $80 and require two hours of labor.
The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Take off the door panel and unbolt the mirror housing