To replace the plastic wheel covers on a 2010 Dodge Journey, first, ensure the vehicle is parked on a flat surface and the engine is off. Carefully pry off the old wheel cover using a flat tool, starting at a corner to avoid damaging the wheel. Align the new wheel cover with the wheel's valve stem and press it firmly into place until it snaps securely. Finally, check that the cover is evenly seated around the wheel and is secure before driving.
It is not really known, it might have been the Journey or the Charger that replaced the Magnum. The real answer is not known.
The taillights are an assembly. The lens covers can not be replaced separately
yes
It is not really known, it might have been the Journey or the Charger that replaced the Magnum. The real answer is not known.
No, they are made into the plastic.
It's directly underneath the plastic cover that covers the top of the engine, the plastic cover pulls off and the intake plenum is underneath it.
open the trunk and there should be a couple screws where the lights are.
It should be under the driver's side dash board, just behind where the plastic covers end
What is the difference between a Dodge Journey SE and a Dodge Journey SXT
Dodge spirit and Plymouth Acclaims use 5 1/4" speakers in front and rear doors. The covers pry off if done gently. The have plastic tabs holding them on. They get brittle so be careful. Just unscrew and install new speakers and snap on the covers. They sell kits a Walmart and other stores if needed for the speakers. I'm getting ready to replace the door speakers in my 94 Dodge Spirit.
On the 2009 Dodge Journey, the brake fluid reservoir is located near the back of the engine bay, on the driver's side, mounted on the master cylinder. It is typically a translucent plastic container with a cap labeled for brake fluid. To access it, you may need to remove any engine covers or components that obstruct your view. Always ensure the vehicle is off and cool before checking the fluid level.
The 2011 Dodge Journey has 16 valves.