0
To replace the power antenna shaft on a 2001 Firebird, first, remove the interior trim panel around the antenna to access the assembly. Disconnect the power connector and unscrew the antenna from its mounting point. Then, pull the broken shaft out and insert the new one, ensuring it is properly aligned. Reassemble the antenna, reconnect the power, and test it to ensure proper operation.
What else can I help you with?
How do you install a power antenna mast or antenna on a four-door 1992 Acura Legend?
go to antennasRus.com buy the shaft and follow their easy instructions, I did it works great
2004 Dakota power steering hard when cold?
disconnect itermediate shaft from rack & pinion check u joint if stiff replace shaft
Where is the throttle position sensor on 97 firebird?
its on the end of the throttle shaft on the throttle body
Why is 95 Kia Sephia power steering pulley wobbling?
Bent shaft, replace PS pump
Why is the antenna on your 98 Cadillac stuck?
either bent shaft or dirty with grime
Where is the speed sensor on a 1987 Pontiac Firebird?
If it has a 700R4, it is in the tail shaft of the tranny on the drivers side.
How do you remove the right front drive shaft on a 1990 LeBaron in order to remove and replace the power steering pump?
you can replace power stering pump without moveing drive shaft but its fiddly. to remove drive shaft undo 30mm nut in centre,undo bottom ball joint and pull strut out of way be ready to catch gear box oil.
Can you replace a universal joint in a 2003 Honda CR-V or do you have to replace the whole drive shaft?
You have to replace the whole drive shaft.
How do you replace a Weed eater FL 20 flex shaft?
i need to replace the flex shaft in my weedeater. how do i do it?
When is time to replace a power steering pump?
excessive noise even though belt tension is good, or when power steering fluid is leaking out the shaft seal.
How do you replace a 1996 infiniti g20 antenna mast?
Buy the replacement antenna from Infiniti if you can afford their inflated price, and follow the directions, it's not that hard. Essentially you undo the ring nut where the antenna goes into the car, turn the radio on so the antenna rises, and it will shove it out of the shaft, along with the ribbed nylon strip that shoves the antenna up and down. To put in the new one, simply thread the nylon strip in the same way the old one came out and have someone turn off the radio. Feed the antenna back in, and put the nut back on. Good Luck!
How do you replace drive shaft on 1990 Toyota Camry?
tool for drive shaft
