this happened my fiesta, an all you do is take the old cable out an feed the new cable up threw, takes time to do, but thats what i did, was going to take the seat about but no need, just feed the cable up threw to the handle, then that should solve your problem.
the mk6 fiesta 1.25 has 75bhp.
Depends on the engine. A variety of different petrol engines and a diesel option were fitted to the Fiesta Mk6. All have different filters.
To remove the air filter on the Fiesta MK6, first remove the bolts on the top of the air filter box. Then, pull upward to remove the rubber gasket around the box. Remove the screws at the rear of the box. Remove the filter and replace it.?æ
Mk6 1.4 Duratec SE 16v 02> gap should be 1.3mm.
A 3-door Mk6 Fiesta tailgate will not fit a 5-door model. The structural differences and mounting points between the two body styles make them incompatible. If you're looking to replace or modify, it's best to source a tailgate that matches the specific body style of your vehicle.
To replace the heater motor in a Mk6 Ford Fiesta, start by disconnecting the battery for safety. Remove the passenger side footwell trim and any necessary panels to access the heater motor housing. Disconnect the wiring harness and unscrew the motor from its mounting. Finally, install the new motor by reversing the steps, ensuring all connections are secure before reconnecting the battery.
Open the hatch and take out the two rubber grommets from behind the brake-light unit. Insert the flat blade of a screwdriver into each hole and press down the spring clip, releasing the light unit from its seat. Drop the hatch and replace the 18watt wedge-ended bulb. Push the unit back into its seat and replace the two grommets.
Nope, pins are different.
in the door panel and in the the rear side panels. hope this helps
The battery is under the driver's seat
To replace the 12V cigarette lighter unit in a 2003 Ford Fiesta MK6, first, disconnect the vehicle's battery to ensure safety. Carefully remove the trim surrounding the lighter using a trim tool or flathead screwdriver, being cautious not to damage it. Once exposed, unscrew the cigarette lighter socket from its mounting, disconnect the wiring harness, and replace it with the new unit. Reassemble the trim and reconnect the battery to complete the replacement.
To replace the pump on a MK6 2002 Fiesta washer bottle, first disconnect the battery for safety. Remove the washer bottle by unscrewing any bolts and disconnecting the hoses and electrical connectors. Take out the old pump from the bottom of the bottle, then install the new pump by reversing the removal process, ensuring all connections are secure. Finally, reattach the bottle to the vehicle and reconnect the battery before testing the new pump.