answersLogoWhite

0

When a freeze plug is damaged, coolant can leak from the vehicle. Using a screwdriver, roll the lip of the plug over toward the middle, being careful not to scratch the sidewall. Grab the lip with a pair of pliers and twist the plug out. Use a hammer to tap in the new plug.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you change a freeze plug on a 1999 sebring convertible?

Call your dealer regarding a recall on Sebring freeze plug leaks. You may get the dealer to repair your problem at no cost.


Replace freeze plug on a 1998 ford Windstar?

Replace freeze plug in a 1998 ford windstar ?


How do you replace freeze plug 1999 Ford Taurus?

How do you replace freeze plug 1999 Ford Taurus?


What Cost to replace freeze out plug in 2000 Chrysler sebring?

They are in the rear of the engine. Two can be reached byt two more are between the bell housing and the engine. Not a do-it-yourself job.


How do you replace a freeze plug in a 1995 Ford Aerostar?

take a large screw driver and a hammer tap the old freeze plug in the block,replace it with a rubber freeze plug.tighten the rubber freeze plug with a wrench..the metal freeze plug that you pushed inside the block will not hurt anything..hope this helps!!!!


Mechanic cost to replace a freeze plug on a Chevy elcamino?

how much does a mechanic charge to replace a freeze plug on a chevy el camino 8.0


How much would it cost to replace a freeze plug on a 1993 cutlass?

It would depend on which freeze plug. Some are easy and some are not.


On a 1999 Sebring is there an additive that can be used to stop freeze plug leak without actually replacing them?

try J.B. weld


Why does your 350 leak antifreeze behind motor mount?

There is a freeze out plug behind it that seals the water jacket up. REPLACE freeze plug.


Where is the Freeze Plug located and how do you replace it 88 sedan deville?

There are about 8 freeze plugs which one is leaking?


How do you replace a freeze plug on Mercedes 1991 190e?

To replace a freeze plug on a 1991 Mercedes 190E, first drain the coolant from the engine. Remove any components obstructing access to the freeze plug, then use a punch or a suitable tool to carefully tap the old freeze plug out. Clean the area before installing the new freeze plug, ensuring it is seated properly, and then reassemble the components. Finally, refill the cooling system with coolant and check for leaks.


What will happen if a freeze plug blows out?

The engine will leak out coolant/antifreeze from the freeze plug area. Freeze plugs can be replaced, it may take a lot of work to replace one but they are made to be replaceable. It is not advisable to drive any vehicle with a blown freeze plug.