answersLogoWhite

0

It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Can you replace the ignition lock cylinder on a 1994 Pontiac firebird without removing the steering wheel?

You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.


How do you replace the ignition cylinder 1992 Bonneville?

I have not seen a way to do it without removing the steering wheel (and airbag).


How do you replace the clutch on a 1995 ford ranger XL with 5 speed manual transmission?

If your asking if it can be done without removing the transmission? NO.


Is there a way to replace the shiftrod seal in a 1990 Ford Probe with a 5-speed transmission without pulling out the entire transmission?

i think you can replace the seal by removing the rubber shift boot


Can you replace engine bearings without removing engine from car?

In some cars, you can get the rear bearing by dropping the transmission. For the rest, no.


Can you replace a spoke without removing the tire?

No, you typically cannot replace a spoke without removing the tire.


Does the engine need to come out to replace the transmission auto98 zx2?

no. you can pull the transmission out without removing the motor. ive done this twice in less than 3 hours


Is it possible to replace the soffit without removing the fascia?

Yes, it is possible to replace the soffit without removing the fascia.


What is the KD 2112 tool used for?

It is used to replace valve seals on many automotive engines without removing the cylinder head from the block.


Can you replace the starter on a 93 Chevy z71 without removing the slave cylinder?

yes,of course- starter has 2 main mounting bolts,and some wiring looms


Where is the transmission filter located on a Honda Odyssey?

Inside the transmission case. It is not servicable without removing and tearing down the transmission.


Can you replace the transaxle out put bushings without removing the transmission in a 99 Buick Lesabre 3.8?

Yes but you must approach it transversely from under the car and then start taking it off.