answersLogoWhite

0

needed:

!. Socket set

2. Jack

3. Blocks to support vehicle.

Jack car up and suspend with blocks,

Remove Tires

under the tie rod you see the bar,

use deep socket on top and regular socket on bottom

do not spin bolt,

unbolt the 2 sides of Bar

lift of bar and remember the position the bar has when it is in as it has a bow in it

replace....

"Compliments of your friendly Neighborhood Satellitedragger"

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the low side service port on a 2000 Buick century?

Where is the lowside service port on a 2000 buick century?


Does a 2000 Buick Century hood fit on a 2000 Buick Regal?

yes


Where can you find a vacuum diagram for a 2000 Buick Century?

i have a 2000 buick century and the evap comes on where and what could be setten off the evap ?


Spark plug gap for 2000 buick century 3.1L V6?

2000 Buick century gap for spark plug 3.1l


Power steering pump Buick century?

I have a 2000 Buick Century costom and I replaced it but it leaks what could be wrong


How do you replace the air filter located on a 2000 Buick Century?

The filter is behind the left headlight, Take the ducting off and get to the filter to change it.


Is a 2000 buick century rear wheel drive?

No


Where is the horn on a 2000 Buick century?

Underneath the right headlight


How do you replace front sway bar on 2000 buick regal?

I have a 2000 Buick Regal GS how do I change my front sway bar


Power window will not go up or down on my 2000 buick century try new door controller check fuse stilll not working?

Replace window regulator.


How to replace a belt tensioner on a Buick century 2000?

Get a Haynes Manual, A Chilton Manual. You can get them at Autozone, Advance Auto, or Napa. They Run under $20. And they are very helpful.


How do you replace horn switch on 2000 Buick Century?

To replace the horn switch on a 2000 Buick Century, first disconnect the negative battery cable to ensure safety. Remove the airbag module by carefully prying off the retaining clips and disconnecting the wiring harness. Once the airbag is removed, you can access the horn switch by unscrewing it from the steering wheel. Replace the old switch with a new one, reassemble everything in reverse order, and reconnect the battery.