To replace the starter in a 2003 6-cylinder F150, first disconnect the negative battery cable to avoid electrical shorts. Then, locate the starter, which is typically mounted near the transmission on the driver's side. Remove the bolts securing the starter, disconnect the electrical connections, and then lift the starter out. Install the new starter by reversing the steps: connect the electrical wires, secure it with bolts, and reconnect the battery cable.
go to following link you will get the answer: http://www.wonderhowto.com/how-to-replace-brakes-2003-f150/
Instructions are in the box the starter came with or go to the manufacturers web site. Not a fun job unless you've done them before & have access to wiring diagrams
setting timing on a f150 4.9 6cyl
Make sure the relay is supplying the 12 volts to the starter - if so remove the starter and go get a rebuilt on to replace it or learn how to repair it yourself.
To replace the starter on a 1985 Ford F150, first disconnect the negative battery cable to ensure safety. Next, locate the starter, which is typically mounted on the engine block near the transmission. Remove the wiring harness and the mounting bolts, then carefully pull out the old starter. Install the new starter by reversing the disassembly steps, ensuring all connections are secure before reconnecting the battery.
When replacing parts of a car, it is important to know the general cost of the fixes. To replace the ball joints for a 2003 F150 pickup truck, it is going to cost a person $40-$60 to do it on their own.
Starter soleniods on Fords are known for problems. They are cheap, just replace it rather then watse time testing it.
Inside the alternator.
Probably in the fuel tank
How do you install a rear sway bar on a 2003 f 150 4 wheel drive
Starter is on the passenger side, bottom of engine going in to bell housing. Remove battery cables(ground side first) 3 bolts hold starter on. 2 wires attached to the end of the starter. reinstall in reverse.
The part of the starter called the starter drive is shot and hopefully the flywheel ring gear is not damaged also. I would recomend removing the starter and inspecting the flywheel ring gear and if it looks okay replace the starter with a rebuilt or new one.