answersLogoWhite

0

Most of the time, the old links are corroded together, and it's much easier to use a cutting torch to remove them. Once they are removed, install new links & bushings (bolt, washer, rubber, sway bar, rubber, washer, sleeve, washer, rubber, control arm, rubber, washer, nut)

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How to replace a heater core in a 1992 GMC Jimmy?

I need to know how to replace a heater core in a 1992 GMC Jimmy?


How do you replace the serpentine belt on a 1992 GMC Safari 4.3L?

I don't know too.


How do you find AC sensor on 1992 GMC pickup?

Where is the AC sensor located on a 1992 GMC pickup


When was GMC Typhoon created?

GMC Typhoon was created in 1992.


How do you replace 02 sensor gmc 1500?

How to replace o2 pre converter gmc 1500


Where is the Mass air flow sensor in a 1992 GMC k3500?

GMC K3500 didn't have a MAF sensor in 1992.


How do you replace wheel bearings on 2004 GMC envoy?

how to replace wheel bearings on 2004 GMC envoy?


How do change the headlights on a 1992 gmc sonoma?

Unscrew the trim piece around the headlights, be careful as to not lose this. Pull the light out, unplug, replace. Simple as that


Where are the fusible links on a 1987 gmc sierra classic?

The fusible links on GMC sierra are on the firewall, left side (passenger) of engine compartment.


Where is the shock fluid filler located on a 1992 GMC Sierra C1500 305?

They're sealed. If the shocks are leaking you'll need to replace them. Always replace them in pairs, both sides at the same time.


Replace a window lift motor for a 1986 GMC sierra?

replace a window lift motor for a 2002 gmc sierra?


How do i replace the battery in 1992 gmc vandura?

To replace the battery in a 1992 GMC Vandura, first ensure the vehicle is turned off and parked on a flat surface. Open the hood and locate the battery; disconnect the negative (-) cable first, followed by the positive (+) cable. Remove any brackets securing the battery, lift it out carefully, and replace it with the new battery, connecting the positive (+) cable first and then the negative (-) cable. Finally, make sure everything is secured and close the hood.