answersLogoWhite

0

The flasher unit is contained inside the hazard light swith on the dash. You need to remove the dash panel and pull the switch out from behind. The entire switch must be replaced which is about - at a Chevy dealer.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is the turn signal flasher on a 2001 Chevy Impala?

The turn signal flasher is integrated with the 4 way flasher switch located on the dash.


How can you replace a beam headlights control impala 2002?

Take it to a dealer. There's no way you'll do it. Proud owner of one.


Replace front cv axle 2002 impala?

I have a bad left front driveshaft on my 2002 Impala 3.8 L v-6 and I need to know what is the easiest way to replace it. I am a a old Chevy master technitition but I have retired and I am look ing for any help I can get to make it easier for me to change it.


How do you replace a 4 way flasher on a 1986 Chevy Astro Van?

It is quite simple to replace the four-way flasher relay switch in your 1986 Chevrolet Astro Van. The four-way flasher relay switch simply plugs in and out.


Where is the turn signal flasher in a 2002 Pontiac Grand Am?

IT IS BEHIND THE FOUR WAY FLASHER SWITCH. IT IS ELECTRONIC AND CAN ONLY BE GOTTEN FROM A DEALER.


In my 2000 Chevrolet Impala my hazard and blinkers dont work all the time could it be my flasher needs to be replaced?

check fuses first... but chances are the flasher, which IS the hazard switch, is faulty... simple to replace ... just remove the left and right fuse box covers and the main dash panel.... replace switch and reinstall panels... be careful of the high beam switch because it seems to get in the way


Where is the 4 way flasher on a 2002 dodge ram 2500 diesel 6 speed or why do the 4 way's not work and both fuses are ok?

Defective Flasher Relay


Where is the turn signal flasher unit on a 2001 Chevy Impala?

I had a problem with my 2004 Impala. The flashers would freeze intermittently, both turn signal and hazards. Therefore I suspected a defective flasher unit. It seems that the hazard switch and flasher are a combined unit and reqiures some dissassembly of the dash to retreive the unit and replace it.AnswerI had to replace the turn signal flasher on my 2000 Impala it is the same unit as the 4 way flasher. The button for the 4 way on the dash is the flasher unit you have to pop off the front of the dash off to get to it there is about 8 screws 2 on the very ends under the fuse covers 2 on the panel under the steering wheel and 2 up by the speed odometer then you pop off the face off the dash be carefull not to brake off the clips Vaughn The flasher unit is a SEPARATE unit located on the left side of the steering column. It costs about $ 15.00 from a NAPA dealer,part # EP 28.The hazard switch costs about $50.00 at NAPA dealer. Chev dealer cost is $95.00The flasher unit and hazard switch work through the same system according to the technician at NAPA. He suggested changing the flasher unit for $15.00 before spending the $50.00 for the hazard warning unit/.


How do you replace the four way flasher switch on a 2002 Saturn vue?

To replace the four-way flasher switch on a 2002 Saturn Vue, start by disconnecting the vehicle's battery to ensure safety. Remove the dashboard trim panel around the switch, which may involve unscrewing screws or gently prying it off. Once the trim is off, locate the flasher switch, disconnect the wiring harness, and remove the switch from its housing. Install the new switch by reversing the process, reconnecting the wiring harness, and reattaching the trim panel before reconnecting the battery.


What is easy way to replace cv joint in 2001 impala?

Take it to a repair shop.


How do you replace a 4-way flasher on a 1995 GMC sierra truck?

To replace the 4-way flasher on a 1995 GMC Sierra truck, first locate the flasher unit, which is typically found under the dashboard near the steering column or in the fuse box. Disconnect the electrical connector from the old flasher and remove it from its mounting position. Install the new flasher by securing it in place and reconnecting the electrical connector. Finally, test the 4-way flashers to ensure they are working properly.


How do you replace the flasher relay on a 1998 Nissan Pathfinder 4WD?

To replace the flasher relay on a 1998 Nissan Pathfinder 4WD, unplug the old turn signal flasher and plug in the new one. It is a three prong plug located under the dash on the driver's side. The hazard flasher relay works the same way.