1. Make sure that when you purchase a new belt, they don't try to sell you the full size serpentine belt.
2. There is a diagram of the belt routing on your truck when you lift the hood. Follow that.
3. Unfortunately, you need to remove the serpentine belt to replace the air conditioning belt.... the belt routing for the serpentine belt is also shown on the diagram.
4. To remove the serpentine belt, get a ratchet set, and crank the "self tensioning" assembly to release tension on the serpentine belt, and remove the belt.
5. There is another "self tensioning" assembly for the air conditioning belt. Crank to place the new AC belt on and release.
6. Re-install the serpentine belt.
This is an easy fix... it took me less than 20 minutes, I'm not a mechanic.
To replace an air conditioner belt on a 1999 Chrysler LHS, rote the the new belt through the pulleys within the engine of your Chrysler vehicle.
You remove the compressor and replace the belt with one for a truck with out ac
To replace the air conditioner belt on a 2000 Chrysler LHS with a 3.5L engine, first, disconnect the negative battery cable for safety. Then, locate the belt routing diagram, usually found near the radiator or on the underside of the hood, to understand how the belt is configured. Loosen the tensioner pulley using a wrench to relieve tension, remove the old belt, and then install the new belt according to the diagram. Finally, re-tension the belt, ensure it's properly aligned, and reconnect the battery cable.
take and measure the routing of belt minus ac and put new belt on
there should only be one belt so stare hard at it and draw a map of how the belt is routed around all the pulleys then use a ratchet or wrench to turn the belt tensioner the correct way slip the belt off then replace according to your diagram There are two belts serpetine belt and one that runs the air conditioner. The air conditioner belt can be found on passenger side look under front bumper.
What is a "belt hose" What is a "belt hose"
The belt is probably glazed. Clean all the pulleys and replace the belt. Do not use a belt conditioner on a serpentine style belt.
if you have to ask how to replace the belt you should not open the hood take it to a shop
There is no fan belt on a Mazda Miata.
NO, you do not remove the head to replace the timing belt on any car.
no. it has a chain not belt. it should last as long as the car.
you dont