To replace the alternator on a 1985 B250 Van, first disconnect the negative battery terminal to ensure safety. Remove the serpentine belt by loosening the tensioner, then unbolt the alternator from its mounting brackets. Disconnect the electrical connectors and take out the old alternator. Install the new alternator by reversing the steps: connect the electrical connectors, secure it with bolts, and reattach the serpentine belt before reconnecting the battery.
Have you replaced the thermostat? On my 92' B250 I had to remove the Alternator and I think the A/C compressor. to properly remove and clean the housing. Also just recently I had to replace the radiator cap.
On my 92 B250, the voltage regulator is integrated right into the alternator. The engine computer is the voltage regulator on a 1989 Dodge Ram Van.
behind the alternator, front passenger side. directly nest to the thermostat housing. DaveF
A Dodge B250 Van does not have a mass airflow sensor.
There's two tabs by the housing you pull up on to release them
To replace an alternator on a 2002 Jaguar van den plas 4.0 simply refer to the user manual.
It is built into the alternator.
Just buy a bypass pulley and bolt it on.
The alternator on a Ford E150 van is replaced by loosing the retaining bolts, removing the belt, disconnecting the wiring harness, and unbolting the alternator. A replacement alternator can then be put into place and reattached.
It's mounted to the firewall. It should say "Electronic" in larger letters and "Voltage Regulator" in smaller letters.
No.
Center of the firewall.