you will have to take all the panels out to back and pull up the cardboard and there are the speakers
To replace the rear speakers in a 2001 Buick Park Avenue, begin by removing the rear speaker grilles, which may require gently prying them off with a flat tool. Next, unscrew and disconnect the old speakers from their wiring harness. Install the new speakers by connecting them to the wiring and securing them with screws. Finally, replace the grilles to complete the installation.
The dash speakers are 3 1/2, and the rear speakers are 5 x 7. If you need to get sizes for your car, go to crutchfield.com and click on outfit my car. It will tell you all the sizes for the speakers in your vehicle!
Chrysler Fifth Avenue was created in 1982.
To replace the speakers in a 1988 Buick Electra Park Avenue, start by removing the door panel or speaker grille to access the speakers. Disconnect the wiring harness from the old speakers and unscrew them from their mounting location. Install the new speakers by reversing the process: secure them with screws, reconnect the wiring, and reattach the door panel or grille. Make sure to test the speakers before fully reassembling to ensure they work properly.
There is no such thing as a 1998 Chrysler Fifth Avenue
There is no such thing as a 1998 Chrysler Fifth Avenue
There is no such thing as a 1998 Chrysler Fifth Avenue
They will be attached by screws from under the rear deck inside the trunk.
There is no such thing as a 1998 Chrysler Fifth Avenue
You have to pull the entire dashboard. I have done it and it gets easier every time. Get the Haynes/Chilton manual and it will tell you how. Get the proper speakers and it is a afternoon job.
U-joints. Get a hammer and a punch. Replace both ends of the drive shaft.
No you don't but if you are putting a different carb on you might have to change the manifold.