0
The foglight switch is a part of the multifunction switch. First you need to disconnect the battery by taking the negative cable off. Then you have to remove 2 Phillips head screws from the plastic cover that is around the steering column. The screws are underneath the cover close to the steering wheel. Carefully remove the bottom half and then the top half. There are 2 T20 torx screws holding the switch on to the column these need to be removed. The switch should then lift up off the guide pins. You need to disconnect the wire harness from the back of the switch. You have to unscrew 2 T10 torx screws that are holding the wiper switch to the multifunction switch. Then you should be able to remove the old switch. You will need to remove the flasher from the back of the switch. It is near where the wiper switch was mounted. It should just pull out. Install it in the new switch then reassemble everything. You also have to remove the trim piece off of the switch. You will need to stretch it over the arm and put it on the new one. I would test the switch before you put the cover back on. The cover has to snap back together as well as screw together. It should take 30 to 45 minutes to complete.
What else can I help you with?
How do you replace rear wiper switch on a 2001 Wrangler?
Remove the dash bezel, remove the switch, reverse process with new switch.
How do you replace the Brake Light Switch in a 2000 ZX2?
how to replace the brake light switch at the pedal of a 2001 ford zx2
Why is your light on 2001 Jeep Wrangler?
If it is a dash warning light, there is a failure causing it. If it is an exterior light, the switch may be on.If it is a dash warning light, there is a failure causing it. If it is an exterior light, the switch may be on.
How do you fix fog lights on a 2001 Jeep Wrangler Sport if they stay on and the switch is off?
take the battery off and then fix the light swish
Where is the turn signal flasher for 2001 jeep wrangler?
The 2001 Jeep Wrangler turn signal flasher relay switch can be located beneath the dashboard. The switch will be on the drivers side of the engine compartment.
On a 2001 Jeep Wrangler Sahara 4.0 ltr the reverse lights are out Does the wiring on top of the transmission have anything to do with it?
Reverse light switch is probaly connected to switch on transmission check connections
2001 I30 how do you replace the interior map light switch?
To replace the interior map light switch in a 2001 Infiniti I30, first, ensure the car is off and disconnect the battery for safety. Use a flathead screwdriver to gently pry off the plastic cover surrounding the map light switch. Remove the screws holding the switch in place, disconnect the wiring harness, and replace it with the new switch. Reassemble the cover and reconnect the battery to complete the installation.
How do you replace the back-light bulb in the headlight switch of a 2001 Dodge Durango?
Pull the switch and change bulb in rear. 1 for night light and 2nd for fog light indicator.
How do you replace hazard switch 2001 Oldsmobile alero?
How do you replace the hazard switch
How do you replace the bulb in the seat heater switch console of a 2001 Subaru Outback Limited Wagon?
The light in the switch can not be changed, the whole switch would need to be replaced.
Where is the fog light switch on a 2001 Jeep Wrangler located?
Try pulling the headlight knob towards you (carefully, don't force it if it doesn't go, but a lot of Chrysler products use this type of switch now).
How do you replace brake light switch for 2001 Mercedes Benz ML55 amg?
To replace the brake light switch on a 2001 Mercedes-Benz ML55 AMG, first, disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is typically found above the brake pedal. Remove the wiring harness from the switch, then unbolt or unscrew the switch from its mounting bracket. Install the new switch by reversing the removal steps, reconnect the wiring, and reattach the battery terminal.
